T25227 Mfg. since 09/13 | Grizzly manual

ELECTRICAL SAFETY. Tool plug must match outlet. Double-insulated tools have a polarized plug (one blade is wider than the other), which must be plugged into a polarized outlet. Never modify plug. Do not use adapter for grounded tools. Use a ground fault circuit interrupter if opera- tion is unavoidable in damp locations. Avoid touching grounded surfaces when operating tool.

WEaring PROPER APPAREL. Do not wear clothing, apparel or jewelry that can become entangled in moving parts. Always tie back or cover long hair. Wear non-slip footwear to avoid accidental slips, which could cause loss of workpiece control. Wear hard hat as needed.

HAzardous DUST. Dust created while using tools may cause cancer, birth defects, or long-term respiratory damage. Be aware of dust hazards associated with each workpiece material, always wear

aNIOSH-approved respirator, and con- nect tool to an appropriate dust collection device to reduce your risk.

Hearing PROTECTION. Always wear hearing protection when operating or observing loud machinery. Extended exposure to this noise without hearing protection can cause permanent hearing loss.

RemovE ADJUSTING TOOLS. Never leave adjustment tools, chuck keys, wrenches, etc. in or on tool—especially near moving parts. Verify removal before starting!

Intended USAGE. Only use tool for its intended purpose. Never modify or alter tool for a purpose not intended by the manufacturer or serious injury or death may result!

AWKWArd POSITIONS. Keep proper footing and balance at all times when operating tool. Do not overreach! Avoid awkward hand positions that make tool control difficult or increase the risk of accidental injury.

Safe HANDLING. Firmly grip tool. To avoid accidental firing, do not keep finger on switch or trigger while carrying.

Forcing Tools. Use right tool for job, and do not force it. It will do job safer and better at rate for which it was designed.

SECURING WOrKPiece. When required, use clamps or vises to secure workpiece. This protects hands and frees both of them to operate tool.

GUards & COVERS. Guards and cov- ers reduce accidental contact with mov- ing parts or flying debris. Ensure they are properly installed, undamaged, and working correctly.

Children & BYSTANDERS. Keep chil- dren and bystanders at a safe distance from the work area. Stop using tool if they become a distraction.

Use RECOMMENDED ACCESSORIES. Consult this manual or manufacturer for recommended accessories. Using improper accessories will increase risk of serious injury.

Maintain WIth CARE. Keep cutting tool edges sharp and clean. Follow all maintenance instructions and lubrication schedules to keep tool in good work- ing condition. A tool that is improperly maintained could malfunction, leading to serious personal injury or death. Only have tool serviced by qualified service- personnel using matching replacement parts.

ChecK DAMAGED PARTS. Regularly inspect tool for any condition that may affect safe operation. Immediately repair or replace damaged or mis-adjusted parts before operating tool.

Maintain POWEr CORDS. When dis- connecting cord-connected tools from power, grab and pull the plug—Not the cord. Carrying or pulling the cord may damage wires inside. Do not handle cord/ plug with wet hands. Avoid cord damage by keeping it away from heated surfaces, high traffic areas, harsh chemicals, sharp edges, moving parts, and wet/damp loca- tions. Damaged cords increase risk of electrocution.

Unattended OPERATION. Never leave tool running while unattended. Turn tool OFF and ensure all moving parts completely stop before walking away.

EXPeriencing Difficulties. If at any time you experience difficulties per- forming the intended operation, stop using the machine! Contact our Technical Support at (570) 546-9663.

T25227 (Mfg. since 09/13)

-3-