User Instructions

•Pivot the handle back to turn the water on, and forward to turn the water off.

•Pivot the handle to the left to make the water warmer, to the right to make the water cooler.

Re-set the high temperature limit stop (optional)

This step should be taken if the faucet is to be used by small children or others who should be protected from scalding.

• Pull out the screw cover, located on the back of the handle.

• Use a 4 mm allen wrench to loosen the set screw.

•Pull off the nut cover and the green high

temperature limit stop ring.

•Reinstall the high temperature limit stop ring so that the black positioning pin is in the notch corresponding to the desired high temperature. The

temperatures shown in the diagram assume an incoming cold water temperature of 50oF and an incoming hot water temperature of 140o.

• Center and replace the nut cover.

• Replace the handle.

•Tighten the set screw.