Product Specification
Max. Flow Rate 2.2 gpm |
|
Max. incoming water pressure | 145 psi |
Recommended water pressure | 14.5 - 72 psi |
Max. hot water temperature | 176o F* |
Recommended hot water temp | 120oF - 140oF* |
Hole size in mounting surface |
|
18010001 | 1 1/4” |
18210001 | 1 3/8” |
Max. mounting surface thickness | 1 5/8” |
Model 18010001 has 10 mm supply hoses
No drain or pull rod is included with model 18010001. Grid drain 06400000 (not included) is recommended.
Model 18210001 has 3/8” supply hoses. 3/8” compression fittings are required (not included). A
*Know and follow all applicable local plumbing codes when setting the temperature on the water heater. In Massachusetts, the water heater may be set no higher than 112oF.
Installation
Position the faucet and sealing ring on the mounting surface.
From beneath the mounting surface, install the fiber washer, metal washer, and mounting nut. Tighten the tensioning screws.
18010001 only: Install the adapters on the stops. Install the filters on the adapters.