Lightolier IS:49126LS instruction sheet Are not Pinched Between Parts, Deco Tube Installation fig

INSTRUCTIONS FOR 9”,12”&16” PENDALYTE™ SERIES TRACK MOUNT TO LYTESPAN ® TRACK SYSTEM

SUSPENSION KITS. FOR USE WITH LYTESPAN TRACK SYSTEMS ONLY.

Note: This instruction sheet covers several luminaire styles. Powerhead assembly, lamp type, and reflector style may vary slightly from that shown, although installation is the same.

CAUTION: MAXIMUM WATTAGE AS MARKED ON LUMINAIRE MUST NOT BE EXCEEDED.

POWERHEAD INSTALLATION (fig. 1):

Note: On 9” unit MOUNT PLATE must be oriented correctly to clear DOOR SCREW head (see fig. 1).

1.	Attach CABLE ADJUSTER to MOUNT PLATE with PANEL NUT.
2.	Pass POWERCORD through relief bushing hole in MOUNT PLATE.
3.	While supporting POWERHEAD ASSEMBLY wire luminaire using WIRE NUTS (local	POWER
	hardware item): black luminaire lead to hot (black) POWERCORD lead, white luminaire lead	STEM
	to neutral (white) POWERCORD lead. Attach luminaire ground wire(s) (green and/or bare) to
	green ground wire from POWERCORD.

4.Height adjustment: to raise luminaire push excess POWERCORD down into POWERHEAD. (Make certain CABLE does not interfere with internal wiring or components, both POWERCORD and CABLE may be cut inside POWERHEAD. Remove DOOR SCREW and pull DOOR away from POWERHEAD). CABLE is inserted into CABLE ADJUSTER. Raise

luminaire by providing slack in CABLE and pushing through CABLE ADJUSTER. Lower				POWERCORD
luminaire by depressing PLUNGER .
5. Secure POWERCORD to MOUNT PLATE with RELIEF BUSHING.
6. Attach MOUNT PLATE to	CAUTION: MAKE CERTAIN WIRES
POWERHEAD with 8-32 SCREWS.				RELIEF
	ARE NOT PINCHED BETWEEN PARTS.
SCREW HEAD / LANCED TAB				BUSHING
TUBE CLIP
	DECO TUBE INSTALLATION (fig. 3)			MOUNT
				PLATE
	1. Slip bottom of TUBE CLIP over TAB on
		bottom of POWERHEAD.
	2.	Pivot top of DECO TUBE assembly until
DECO		top of TUBE CLIP snaps over SCREW
		HEADS (9” units) or LANCED TABS
TUBES
		(12”&16” units).
	3.	Repeat for remaining tube	WIRE NUTS

POWERHEAD

TRACKASSEMBLY

BEAD	STEM LEVER
TAB

Fig. 3

SUSPENSION

STEM

CABLE

CABLE ADJUSTER

8-32 SCREWS

PANEL NUT

DOOR

SCREW

DOOR

DIFFUSER DISC INSTALLATION (fig. 4)

1.	Install DECO TUBE assemblies to
	POWERHEAD first.
2.	Align holes in DISC with ends of DECO
		Fig. 2
	TUBES.

Fig. 1

NOTE: Not for use with ProSpec track.

	DISC
Fig. 4	CAP NUTS

INSTALLATION INTO TRACK (fig. 2)

1.Turn off power to TRACK.

2.Insert SUSPENSION STEM into track. The STEM LEVER must be on the same side as the track bead. See fig. 2.

3.Rotate suspension stem 90° clockwise using STEM LEVER. STEM LEVER should be parallel to TRACK.

4.To remove: rotate SUSPENSION STEM 90° counterclockwise using STEM LEVER.

5.Repeat steps 2 and 3 with POWER STEM.