Radio Shack 40-4092 1706+06*52#-4, 52%++%#6+105, To connect in parallel, To connect in series

Limited Two-Year Warranty	1.	Separate about 4 inches of speaker wire			wire to the left channel of the amplifier's
		at each end.			negative (–) terminal.
This product is warranted by RadioShack against				4. Repeat Step 3 to connect the remaining
manufacturing defects in material and workmanship
under normal use for two (2) years from the date of					set of wires to the receiver’s right
purchase from RadioShack company- owned stores			1/4 inch		channel terminals.
and authorized RadioShack franchisees and dealers.
EXCEPT AS PROVIDED HEREIN, RadioShack
MAKES NO EXPRESS WARRANTIES AND ANY IM-				/101"%10(+)74#6+10
PLIED WARRANTIES, INCLUDING THOSE OF
			4 inches
MERCHANTABILITY AND FITNESS FOR A PARTIC-				Wire the two sets of terminals located on the
ULAR PURPOSE, ARE LIMITED IN DURATION TO	2.	Using a wire stripper, remove about 1/4		back of the speaker in parallel or series.
THE DURATION OF THE WRITTEN LIMITED WAR-
RANTIES CONTAINED HEREIN. EXCEPT AS PRO-		inch of insulation from each wire. Then		To connect in parallel:
VIDED HEREIN, RadioShack SHALL HAVE NO		twist the ends of each wire.
LIABILITY OR RESPONSIBILITY TO CUSTOMER
OR ANY OTHER PERSON OR ENTITY WITH RE-				1. Using two pieces of wire, connect both
SPECT TO ANY LIABILITY, LOSS OR DAMAGE	56'4'1"%10(+)74#6+10
					sets of red terminals together and both
CAUSED DIRECTLY OR INDIRECTLY BY USE OR
PERFORMANCE OF THE PRODUCT OR ARISING	1.	Connect the marked wire to a red			sets of black terminals together.
OUT OF ANY BREACH OF THIS WARRANTY, IN-
		speaker terminal by pressing the release
CLUDING, BUT NOT LIMITED TO, ANY DAMAGES				2. Connect the wires from the receiver to
RESULTING FROM INCONVENIENCE, LOSS OF		tab, inserting the wire into the hole, and
					one set of terminals as described in
TIME, DATA, PROPERTY, REVENUE, OR PROFIT		then releasing the tab. Repeat this
OR ANY INDIRECT, SPECIAL, INCIDENTAL, OR					“Stereo Configuration” Step 1.
		procedure to connect the unmarked wire
CONSEQUENTIAL DAMAGES, EVEN IF RadioShack
HAS BEEN ADVISED OF THE POSSIBILITY OF		to the black terminal on the same		To connect in series:
SUCH DAMAGES.		terminal block.
Some states do not allow limitations on how long an				1. Using one piece of wire, connect the red
implied warranty lasts or the exclusion or limitation of	2. Repeat Step 1 to connect the second set
incidental or consequential damages, so the above					terminal of one set of terminals to the
limitations or exclusions may not apply to you.		of wires to the other terminal block.
					black terminal of the other set.
In the event of a product defect during the warranty
period, take the product and the RadioShack sales re-	3.	For the first set of wires, connect the
ceipt as proof of purchase date to any RadioShack				2.	Connect the wires from the receiver to
store. RadioShack will, at its option, unless otherwise		marked wire coming from the speaker to			the remaining black and red terminals.
provided by law: (a) correct the defect by product re-		the left channel of the receiver's positive
pair without charge for parts and labor; (b) replace the
		(+) terminal. Then connect the unmarked
product with one of the same or similar design; or (c)
refund the purchase price. All replaced parts and
products, and products on which a refund is made, be-	/1706+0)"6*'"52'#-'4
tioned parts and products may be used in the
come the property of RadioShack. New or recondi-
performance of warranty service. Repaired or re-	1.	Remove the grille to expose the		4.	Replace the grille.
placed parts and products are warranted for the re-
mainder of the original warranty period. You will be		mounting screws.
charged for repair or replacement of the product made
after the expiration of the warranty period.	2. Be sure the mounting tabs are turned in,			Mounting Tabs
This warranty does not cover: (a) damage or failure
		allowing the speaker to fit into the hole.
caused by or attributable to acts of God, abuse, acci-
dent, misuse, improper or abnormal usage, failure to		Then insert the speaker into the
follow instructions, improper installation or mainte-		mounting hole.
nance, alteration, lightning or other incidence of ex-
cess voltage or current; (b) any repairs other than	3.	Use the four screws to tighten the
those provided by a RadioShack Authorized Service
Facility; (c) consumables such as fuses or batteries;		mounting tabs to the wall or ceiling. Be		To remove the speaker from the wall or
(d) cosmetic damage; (e) transportation, shipping or		careful not to overtighten the screws.
insurance costs; or (f) costs of product removal, instal-				ceiling, loosen the screws only far enough to
lation, set-up service adjustment or reinstallation.				remove the speaker. This will prevent loss of
This warranty gives you specific legal rights, and you
				the mounting tabs.
may also have other rights which vary from state to
state.
RadioShack Customer Relations, 200 Taylor Street,	52'%+(+%#6+105
6th Floor, Fort Worth, TX 76102
12/99
	Resonance Frequency				55 Hz ±20%
	Frequency Response				30 Hz through 20 kHz
	Power Rating				40 Watts RMS, 80 Watts Max.
	Impedance (nominal)				8 Ohms
	Sensitivity...Mono (Series/Parallel), Stereo				83 dB ±3 dB
	Voice Coil (Woofer 4 layer)				1 in. (25 mm)
	Voice Coil (Tweeter ea.)				.55 in. (14 mm)
	Magnet Size (Woofer)				11 oz

The plastic enclosure for this speaker meets UL 94 requirements for flammability.

Specifications are typical; individual units may vary. Specifications are subject to change or improvement without notice.

RadioShack Corporation	40-4092
	03A02
Fort Worth, Texas 76102	Printed in China