Samsung SGH-250SEFDTC Charging a Battery Pack, Switching the Phone On and Off, Power Off appears

Page 10

01-250 4/2/99 11:48 AM Page 18

Charging a Battery Pack

You are supplied with a battery charger that must be plugged into an appropriate wall socket (230V, 50Hz). For more details about charging times, see page 16.

Switching the Phone On and Off

A mobile phone can only place and receive calls when it is switched on.

• The battery pack may become warm during charging. See pages 12 and 13 for various safety precautions to be taken with the battery pack.

When the battery is discharged, and Low Battery are displayed. Refer to the table in Step 3.

1. Switch the phone on by pressing / I for at least two seconds.

Result:

• The phone gives a long beep

• The greeting message is displayed

MENU

OK

C

1

2

3

1.Plug the travel adapter into the bottom of the handset.

2.Plug the travel adapter into an appropriate wall socket.

Result:

Charging begins

The battery status indicator blinks

You can use the phone while charging the battery pack. However, the charge time will be longer.

3.When is displayed (charging is finished), unplug the adapter from the phone by:

Pressing the two buttons on the sides of the adapter plug

Pulling the plug

Refer to the table below when checking the battery status.

Indication

Battery Status

 

Discharged

 

1/3 full

• The phone scans for the available

network; when the network name

is displayed, you can place and

receive calls

• If Phone Lock is displayed, enter the password first (see page 49).

When you switch the tele- phone on for the first time, Enter PIN: is displayed (see page 20).

If Check Card is displayed, check that your SIM card is correctly installed (see page 15).

2.When you have finished using the phone, switch it off by pressing / I again for two seconds.

Result:

The phone gives a long beep

Power Off appears

The display is cleared

The battery is no longer being used

 

 

MENU

OK

C

 

1 .

2

3 DEF

Power Off

4

18

2/3 full

Fully charged

4.Unplug the adapter from the wall socket.

To enable the phone to lock automatically when switched off. See page 49.

19

Image 10
Contents Mobile Phone 01-250 4/2/99 1147 AMClear/Cancel button OK Dial/Entry button Rear View of the Phone Without the BatteryLCD display Battery release button SIM card holderNo service Handset Display and IndicatorsParts List ActivatedWarranty Details ContentsSymbols General Safety Precautions Battery Safety Precautions Inserting Your SIM Card Gold-coloured chip shouldBattery Types Attaching and Removing a Battery PackPower Off appears Charging a Battery PackSwitching the Phone On and Off Power OffExtending the Antenna When Enter PIN is displayed, enter your PINEntering Your PIN Code Enter PIN„English Italian French Selecting a Menu OptionChoosing Your Language To exit Press+8225413000 appears Placing a Call+8225413000 0005 Call EndedReceiving a Call 02-250 4/2/99 1135 AMViewing Information about Calls Resetting the Call TimerCall Timer Reset is displayed To displaySelecting the Ringing Tone Adjusting the Ringing VolumeRing Volume Silent Normal 02-250 4/2/99 1136 AMMuting the Microphone Adjusting the Key VolumeAdjusting the Earpiece Volume +8225413000 0000Automatic Redialling Redialling One of the Last Ten NumbersButton Location003 Enter Tel 086519412532 To...PressResult Enter Name appears Replace it with New one Cancel Operation Go back toPress to enter the phone book menu Result Enter name is displayed02-250 4/2/99 1137 AM Using Speed DiallingDialling a Stored Number CallingNot Found appears Scanning the Phonebook by NamesScanning the Phonebook by Memory Locations To ...Press02-250 4/2/99 1138 AM Deleting a Phonebook Entry by NameDeleting a Phonebook Entry by Memory Location Location 003 Clear?Result Password ? appears Preventing Access to Your Phone SettingsPreventing Access to the Memory Registers Block onDisplaying Your Own Phone Number Locking the PhoneResult New Code Again Preventing Access to Your PhoneChanging Your PIN If the PIN entered Then Steps 4 and 5 areResult New Code Again appears Changing the Phone’s PasswordChanging the Greeting Message Steps 5 and 6 areRings or OFF Customising Your Phone’s FeaturesRings, 5 Rings If network or OFFDefault Setting is displayed Resetting the Phone’s FeaturesPassword? Function Default SettingAuto „Manual Searching for a Network AutomaticallySearching for a Network Manually Please WaitEditing a Network List Call BarringResult Please Wait appears Call Barring Checking the Call Barring StatusRefused is Changing the Call Barring Service Password Call DivertingPlease Wait Divert All Active Using the Call Waiting FeaturesChecking the Call Diversion Status If the call Then Waiting04-250 4/2/99 1122 AM Holding a CallReading a Short Message If you want to Then pressResult Message Deleted appears Reading a Short Message Creating a Short MessageResult Delete? appears Message sentIf you Entering SC Address04-250 4/2/99 1123 AM Enter Tel No appearsCalls Missed Call ServiceCleaning Your Mobile Phone Missed Call Erase ?Problems and Solutions Glossary of Terms Code No.GH68-60588A Basic.05/98.Rev.3.0