Connections
Speaker Components
|
|
|
| ||
(L) | (R) | (L) | (R) |
|
|
FRONT | SURROUND | CENTRE | SUBWOOFER |
Speaker Components | Assembled Speakers | |
|
| |
(L) (R) | SCREW (5X15): 4EA |
|
| SCREW (4X20): 16EA | CENTRE |
|
| SPEAKER |
FRONT STAND | SPEAKER CABLE | |
(L) (R)
CENTRE |
|
|
|
STAND BASE | FRONT | SURROUND | SUBWOOFER |
SPEAKER | SPEAKER |
| |
SURROUND SUBWOOFER |
|
|
|
Installing the Speakers on the Tallboy Stand
HT-D4550 only
1.Turn the Stand Base upside-down and connect it to the Stand.
2.Insert small screws (4x20, For connecting Stand & Stand Base) clockwise into the four holes marked using a screwdriver as shown in the illustration.
!CAUTION
When you use a torque screwdriver, be careful not to put excessive force. Otherwise, it runs idle or can be damaged. (torque screwdriver- below 15 kg.f.cm)
3.Connect the upper Speaker to the assembled Stand.
4.Insert another large screw (5x15, For connecting Speaker & Stand) clockwise into the hole on the rear of the speaker using a screwdriver.
5.This is the appearance after the speaker is installed. Follow this steps to install other speaker.
1 |
| 2 |
| Stand |
|
| Base |
|
| Stand |
|
3 | Speaker | 4 |
|
|
Stand
5