Samsung HT-E5200/XE, HT-E5200/XN, HT-E5200/EN, HT-E5200/ZF manual Wi-Fi Direct

4 . If you select the Add Network, enter your wireless router's name to connect.

Enter numbers directly using the number buttons on your remote control. Enter letters by selecting a letter with the ▲▼◄► buttons, and then pressing the E button.

Select Next, and then press the E button again. You can select security type, and then select Next, and then press the E button again.

5 . On the Security screen, enter your network's Security Code or Pass Phrase.

Enter numbers directly using the number buttons on your remote control. Enter letters by selecting a letter with the ▲▼◄► buttons, and then pressing the E button.

6 . When done, select Next at the right of the screen, and then press the E button.

7 . The Network Status screen appears.

The product attempts to verify the network connection and fails.

8 . Select IP Settings on the right of the screen, and press the E button. The IP Settings screen appears.

9 . Select the IP Mode field, and then set it to Manual.

10 . Use the number keypad on your remote to enter the Network values. Use the ▲▼◄► buttons on the remote to move from entry field to entry field.

NOTE

You can get these values from your Internet provider. You can also view these values on most Windows computers. For instructions, see "Getting the Network Settings Values." on page 29.

11 . When done, highlight OK, and then press E button. The Network Status screen appears. The product verifies the network connection and then connects to the network. When it is done, highlight OK, and then press E button.

❑WPS(PBC)

One of the easiest ways to set up the wireless network connection is using the WPS(PBC) function. If your wireless router has a WPS(PBC) button, follow these steps:

1 . Open the Home screen.

2 . Press the BLUE (D) button on the remote control.

3 . Press the WPS(PBC) button on your router within two minutes. Your product automatically acquires all the network settings values it needs and connects to your network.

The Network Status screen appears. The product connects to the network after the network connection is verified.

Wi-Fi Direct

The Wi-Fi Direct function allows you to connect Wi-Fi Direct devices to the product and each other using a peer-to-peer network, without a wireless router.

1 . Turn on the Wi-Fi direct device and activate its Wi-Fi Direct function.

2 . In the Home screen, select Settings, and then press the E button.

3 . Select Network, and then press the E button.

4 . Select Wi-Fi Direct, and then press the E button.

The Wi-Fi Direct devices that you can connect appear.

Device Name : [HTS]E5200	Wi-Fi Direct
Display
Select your Wi-Fi Direct device to connect to.
Audio	Disconnected
AndroidXXXXXXX
Network		Refresh
System
		Close
Support	m Move " Enter	' Return

5 . You have three ways to complete the Wi-Fi connection:

•Through the Wi-Fi device.

•Through the product using PBC.

•Through the product using a PIN.

Each is covered below.

English 31

04 Settings

HT-E5200_XU_0223.indd 31 2012-02-23 오후 2:30:04