Samsung DVD-R125P manual Connecting HDMI/DVI to a, Case 2 Connecting to a TV, With DVI Jack

Setting Up

Connecting HDMI/DVI to a

TV

If your TV has a HDMI/DVI input, connect HDMI/DVI cable to a TV. You will enjoy the best quality images and sounds.

● Case 1 : Connecting to a TV with HDMI Jack red white

Connecting &

●Case2 : Connecting to a TV with DVI Jack

Case 1 : Connecting to a TV with HDMI Jack

• Using the HDMI cable connect the HDMI OUT

white

red

jack on the rear of the DVD Recorder to the HDMI IN jack of your TV.

• Press the input selector on your TV remote control until the HDMI signal from the DVD Recorder appears

on your TV screen.

To change HDMI output resolution, see page 37.

NOTE

HDMI (High Definition Multimedia

Interface)

HDMI is an interface to enable the digital transmission of video and audio data with just a single connector. Since HDMI is based on DVI, it is completely compatible with DVI. The only difference between HDMI and DVI is that HDMI supports multi-channel audio.

Using HDMI, the DVD recorder transmits a digital video and audio signal and displays a vivid picture on a TV having an HDMI input jack.

HDMI connection description

HDMI connector - Both uncompressed video data and digital audio data (LPCM or Bit Stream data).

Case 2 : Connecting to a TV	- Though the DVD recorder uses a HDMI
	cable, the DVD recorder outputs only a
with DVI Jack	pure digital signal to the TV.

•Using the DVI Adapter Cable, connect the HDMI OUT jack on the rear of the DVD Recorder to the DVI IN jack of your TV.

•Using the audio cables, connect the AUDIO (red and white) OUT jacks on the rear of the DVD Recorder to the AUDIO (red and white) IN jacks of your TV. Turn on the DVD recorder and TV.

•Press the input selector on your TV remote control until the DVI signal from the DVD Recorder appears on your TV screen.

■ To watch through the HDMI output, set

- If TV does not support HDCP (High- bandwidth Digital Content Protection), snow noise appears on the screen.

Why does Samsung use HDMI?

Analog TVs require an analog video/audio signal. However, when playing a DVD, the data transmitted to a TV is digital.

Therefore either a digital-to-analog converter (in the DVD Recorder) or an analog-to-digital converter (in the TV) is required. During this conversion, the picture quality is degraded due to noise and signal loss. HDMI technology is superior because it requires no D/A conversion and is a pure digital signal from the DVD recorder to your TV.

CAUTION

the digital audio output to PCM. See page 33~34.

What is the HDCP?

■Depending on the HDMI device (TV/HDMI Receiver) you use, audio may not be supported. If TV does not support Dolby digital/DTS, Audio output is not available when you set Digital output as Bitstream or select DTS On in Audio setup menu. In this case, set the digital audio output to PCM or DTS off.

HDCP (High-bandwidth Digital Content Protection) is a system for protecting DVD content outputted via HDMI from being copied. It provides a secure digital link between a video source (PC, DVD. etc) and a display device (TV, projector. etc). Content is encrypted at the source device to prevent unauthorized copies from being made.

22- English