Samsung UBD-M9500/XE, UBD-M9500/EN Wireless Network, Press the OK button ĞĞ Wired Manual, Wpspin

6.The product detects the wired connection, verifies the network connection, and then connects to the network.

7.Press the (OK) button.

ĞĞWired - Manual

If you have a static IP address or the Automatic procedure does not work, you'll need to set the Network Settings values manually.

Follow Steps 1 and 3 in Wired - Automatic, and then follow these steps:

1.Select Network Status. The product searches for a network, and then displays the connection failed message.

2.On the bottom of the screen, select IP Settings, and then press the (OK) button. The IP Settings screen appears.

3.Select the IP Settings field, and then press the (OK) button.

4.Select Enter manually in the IP Settings field, and then press the (OK) button.

5.Select a parameter to enter (IP Address, for example), and then press the (OK) button. Use the Up/Down buttons on the remote control to enter the numbers for the parameter.

Use the Left/Right buttons on the remote control to move from entry field to entry field within a parameter. When done with one parameter, press the (OK) button.

6.Press the Up or Down button to move to another parameter, and then enter the numbers for that parameter following the instructions in Step 5.

7.Repeat Steps 5 and 6 until you have filled in all parameters.

NOTE

\\ You can get the Network parameters from your Internet provider.

8.When finished entering all the parameters, select OK, and then press the (OK) button. The product verifies the network connection and then connects to the network.

Wireless Network

You can set up a wireless network connection in four ways:

-- Wireless Automatic -- Wireless Manual -- WPS(PBC)

-- WPS(PIN)

When you configure the wireless network connection, any wireless network devices currently connected through the product or, if applicable, the product's current wired connection, will be disconnected.

ĞĞWireless - Automatic

1.In the Home screen, select Settings, and then press the (OK) button.

2.	Select General, and then press the	(OK)
3.	button.	(OK)
	Select Network, and then press the
	button.

4.Select Network Settings, and then press the (OK) button.

5.Select Wireless in the Network Type screen, and then press the (OK) button.

Wireless Connection

iptime23 iptime solugen_edu#2

Refresh

6.Select the desired network, and then press the (OK) button.

NOTE

\\ Alternatively, select Add Network at the bottom of the wireless network list to establish a connection. This method can be used when you know the SSID (name) of the wireless router.

04 Settings

27 English