![](/images/new-backgrounds/1275813/27581333x1.webp)
Installing the Speakers on the Tallboy Stand
02 Connections
*
*
1.Turn the Stand Base
2.Insert small screws (4*20, For connecting Stand & Stand Base) clockwise into the four holes marked using a screwdriver as shown in the illustration.
!CAUTION : When you use a torque screwdriver, be careful not to put excessive force. Otherwise, it runs idle or can be damaged. (torque screwdriver- below 15 kg.f.cm)
3.Connect the upper Speaker to the assembled Stand.
4.Insert another large screw (5*15, For connecting Speaker & Stand) clockwise into the hole on the rear of the speaker using a screwdriver.
5.This is the appearance after the speaker is installed. Follow this steps to install other speaker.
Connecting The Speakers
1
Stand
Base
Stand
3
Speaker
Stand
5
2 |
4 |
1. Press down the terminal tab on the back of the speaker.
2. Insert the black wire into the black terminal
3. Connect the connecting plugs to the back of the product by matching the | Black | Red | |
colours of the speaker plugs to the speaker jacks. | |||
|
|
In case of |
|
| Centre Speaker |
Front Speaker (R) | Front Speaker (L) |
| |
| DIGITAL |
| AUDIO IN |
| OPTICAL |
| iPod |
Rear Speaker (R) | Rear Speaker (L) |
Subwoofer
* Refer to page 16 for the speakers of