Samsung HT-D455/ZF Installing the Speakers on the Tallboy Stand, Connecting The Speakers, Black

Installing the Speakers on the Tallboy Stand

02 Connections

*HT-D453 only - Front Speakers

*HT-D455 only - Front/Surround Speakers

1.Turn the Stand Base upside-down and connect it to the Stand.

2.Insert small screws (4*20, For connecting Stand & Stand Base) clockwise into the four holes marked using a screwdriver as shown in the illustration.

!CAUTION : When you use a torque screwdriver, be careful not to put excessive force. Otherwise, it runs idle or can be damaged. (torque screwdriver- below 15 kg.f.cm)

3.Connect the upper Speaker to the assembled Stand.

4.Insert another large screw (5*15, For connecting Speaker & Stand) clockwise into the hole on the rear of the speaker using a screwdriver.

5.This is the appearance after the speaker is installed. Follow this steps to install other speaker.

Connecting The Speakers

1

Stand

Base

Stand

3

Speaker

Stand

5

2

4

1.Press down the terminal tab on the back of the speaker.

2. Insert the black wire into the black terminal (–) and the red wire into the red terminal (+), and then release the tab.

3.Connect the connecting plugs to the back of the product by matching the

colours of the speaker plugs to the speaker jacks. Black Red

In case of HT-D450

Front Speaker (R)

Surround Speaker (R)

Center Speaker

Front Speaker (L)

Surround Speaker (L)

Subwoofer

* Refer to page 16 for the speakers of HT-D453/D455.

English 17

HT-D450-XU-ENG-1228.indd 17 2011-12-28 ￿￿ 5:10:00