Samsung SPA400BX/EDC, SPA400BCX/EDC manual Unplug the power plug before cleaning the product

Page 3

To disconnect the apparatus from the mains, the plug must be pulled out from the mains socket, therefore the mains plug shall be readily operable.

zThere is a danger of electric shock or fire.

Always unplug the unit by holding the power plug. Pulling the power cable may damage the inside of it.

zThere is a danger of fire.

Unplug the power plug before cleaning the product.

zThere is a danger of electric shock or fire.

Power Related Installation Related Cleaning and Use Related

TO PREVENT THE SPREAD OF FIRE, KEEP CANDLES OR OTHER OPEN FLAMES AWAY FROM THIS PRODUCT AT ALL TIMES.

zThere is a danger of fire.

When installing the product in a cabinet or on a shelf, make sure the front end of the base does not protrude.

zDropping the product may damage it or cause injury.

Keep the power cord away from heaters.

zThe coating of the power cord may melt and cause electric shock or fire.

Do not install the product in locations exposed to oil, smoke, moisture or water (rainwater), or in a vehicle.

zThere is a danger of electric shock or fire.

Do not install the product in locations with poor ventilation such as a bookshelf, closet, etc.

z An increase in the internal temperature may cause a fire.

Image 3 Contents
Page Do not plug multiple devices into a single wall outlet Insert the power plug firmly so that it does not come looseDo not use loose power outlets or damaged power cables Under no circumstances touch the power plug with wet handsKeep the power cord away from heaters Unplug the power plug before cleaning the productPlace the product on the ground carefully Do not drop the product while carrying itKeep the product out of children’s reach If swallowed, see a doctor immediately Do not disassemble, or attempt to fix or modify the productTake care not to lose the lens cover of the product Make sure to place your remote control on a table or deskPage Front/Upper Side Optical engine with advanced DLP technologyUnpacking Adjustable FeetLED Indications Clearing Indicator ProblemsRear Side CenterMove /ENTER OFFModel Supported Display Modes Hdmi Supported Resolution/Size ModesPicture Position Modes 480i 169 Mode Zoom and Focus Adjustment Installing the ProjectorSelect Menu Setup Install Rear-Floor Select Menu Setup Install Front-FloorScreen Size and Projection Distance Leveling with Adjustable FeetScreen Rear of Projector Connecting a DVD player/Cable/Satellite Box to HDMI/DVI Using the ProjectorConnecting a DVD player/Cable/Satellite Box via Component Connecting to PC Connecting to VCR/CamcorderConnecting Video Devices Monitor, TV, etc Page Component Video Movie1, Movie2 You can only adjust Sharpness in S-Video and Video modesYou can only adjust Tint in S-Video and Video modes Standard169 Color Temperature Offset GainPosition Adjust the screen position if it is not aligned FullLight Setting InstallOnly activated in the PC environment Maximum and then perform Fine Adjustment again60 sec Time Sec 90 sec 10 sec 120 sec 30 secOff Installation and Connection Menu and Remote ControlScreen and External Source Page Lamp Replacement To clean the exterior and lens of the projectorClean the projector using a soft dry cloth To clean the interior of the projectorLamp Replacement Procedure Latin America Switzerland Analog Broadcast Backlight Remote ControlColor Temperature Gamma ModeSatellite Broadcast RS-232C Port Service Input PortOverscan Video in Port
Related manuals
Manual 40 pages 52.21 Kb Manual 40 pages 48.75 Kb Manual 37 pages 2.02 Mb Manual 38 pages 20.38 Kb Manual 40 pages 17.69 Kb Manual 40 pages 32.12 Kb Manual 39 pages 19.59 Kb Manual 41 pages 3.78 Kb Manual 39 pages 31.46 Kb Manual 39 pages 17.03 Kb Manual 41 pages 55.43 Kb Manual 37 pages 1.41 Mb Manual 38 pages 55.13 Kb Manual 38 pages 58.44 Kb Manual 40 pages 57.72 Kb