548+%#0&42#+4, #6+014/#6+10 | Radio Shack 21-1863 specs

5'66+0)"6*'"%1746'5;"610'

You can set your radio so the person you are communicating with hears a tone when you finish transmitting. To turn on the radio’s

courtesy tone, hold down MENU/QUIET until 9#JED; flashes. Ed appears when the

courtesy tone is on and E<< appears when it is off. Press SCAN/¼ý or ¹/CALL to turn the courtesy tone on or off, then press PTT to store the setting. Otherwise, the radio stores the displayed setting after about 15 seconds.

75+0)"6'"$#%-.+)6

Your radio’s display has a backlight that turns on for about 10 seconds when you press any key except PTT. To turn on the backlight without changing the radio’s settings, press MON. ±

5'66+0)"6*'"-';"610'

You can set the radio so it sounds a tone when you press any key except PTT or MON. To turn on the key tone, hold down MENU/ QUIET for about 2 seconds to enter menu mode, then continue to press MENU/QUIET

until flashes.. Ed appears when the key tone is on and E<< appears when it is off. Press SCAN/¼ or ¹/CALL to turn the key tone on or off. Press PTT or MENU/QUIET to store the setting or it will store the displayed setting after 15 seconds.

75+0)"6*'"59+8'."$'.6"%.+2

To attach the belt clip, insert the clip into the socket at the back of the radio until it clicks. To remove the belt clip, press the button at the top of the clip and pull out the clip.

75+0)"#0"126+10#."

94+56"564#2

You can attach an optional wrist strap (not supplied) to the radio. Slide the wrist strap’s small loop under the bar on the top of the radio. You might need to use a small screw- driver or straightened paper clip to do this. Then pull the strap’s large loop through the small loop.

%#4'

Keep the radio dry; if it gets wet, wipe it dry immediately. Use and store the radio only in normal temperature environments. Handle the radio carefully; do not drop it. Keep the radio away from dust and dirt, and wipe it with a damp cloth occasionally to keep it looking new.

5'48+%'"#0&"4'2#+4

If your radio is not performing as it should, take it to your local RadioShack store for assistance. Modifying or tampering with the radio’s internal components can cause a malfunction and might invalidate its warranty and void your FCC authorization to operate it.

(%%"+0(14/#6+10

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

When the Push-to-Talk (PTT) button is pressed, it sends out radio frequency signals. The device is authorized to operate at a duty factor not to exceed fifty percent. In August 1996, the Federal Communications Commission adopted RF exposure guidelines with safety levels for handheld wireless devices.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.

•Consult your local RadioShack store or an experienced radio/TV technician for help.

If you cannot eliminate the interference, the FCC requires that you stop using your radio.

Changes or modifications not expressly approved by RadioShack may cause interference and void the user’s authority to operate the equipment.

You must use shielded interface cables with this equipment.

5#('6;"+0(14/#6+10

Do not open your radio to make any internal adjustments. Your radio is set up to transmit a regulated signal on one of 14 assigned frequencies. It is illegal to alter or adjust the settings inside the radio to exceed those limitations. Any adjustments to your radio must be made by a qualified technician using the proper test equipment. .

±"016'"±"

You cannot turn on the backlight while the radio is receiving a signal.

."%#76+10".

•To maintain compliance with the FCC’s RF exposure guidelines, hold the transmitter and antenna at least 2 inches (5 cm) from your face and speak in a normal voice, with the antenna pointed up and away from your face. If you wear the handset on your body while using the headset accessory, use only the supplied belt clip for this product and when transmitting, take it out of the belt to ensure the antenna is at least 1 inch (2.5 cm) from your body.

•Use only the supplied antenna. Unauth- orized antennas, modifications, or attach- ments could damage the transmitter and may violate FCC regulations.