Samsung MAXZJ650RH/EDC, MAXZJ650RH/ELS manual Setting the Clock

DEMO/DIMMER function

GB

All functions available on the system can be viewed on the display and the display's brightness can be switched between "on" and "off".

1	Press the DEMO/DIMMER button.
	Result: All functions available on the system appear on the front
	panel display.
	Each of these are explained in detail in this guide. Please refer to
	the relevant section.
2	Press the DEMO/DIMMER button again.
	Result: The Dimmer function is selected and the display darkens.
3	Press the DEMO/DIMMER button once again to brighten the front
	panel display.

A display brightness control can only be performed while the system power is on.

Setting the Clock

Your system is equipped with a clock which allows you to turn your system on and off automatically.

You should set the clock:

When you first purchase the mini-compact system

After a power failure

After unplugging the unit

For each step, you have a few seconds to set the required options. If you exceed this time, you must start again.

1	Switch the system on by pressing STANDBY/ON.
2	Press TIMER/CLOCK twice.
	Result: CLOCK is displayed.
3	Press ENTER.
	Result: The hour flashes.
4
	To...	Turn the MULTI JOG knob to the...
	Increase the hours	Right
	Decrease the hours	Left
5	When the correct hour is displayed, press ENTER.
	Result: The minutes flash.
6
	To...	Turn the MULTI JOG knob to the...
	Increase the minutes	Right
	Decrease the minutes	Left
7	When the correct time is displayed, press ENTER.
	Result: The clock starts and is displayed, even when the system is in

standby mode.

You can display the time, even when you are using another function, by pressing TIMER/CLOCK once.

You can also use / buttons on the panel front or TUNING/ALBUM / on the remote control to instead of MULTI JOG knob in step 4, 6.

You can also use PROGRAM/SET button on the remote con- trol instead of ENTER button in step 3,5,7.

10