Rear Panel View
GB
1
2
3
4
5
1.AM Aerial Connector Terminals
2.FM Aerial Connector Terminal
3.CD Digital Out (optical)
4.Speaker Connector Terminals
5.
Where to Install Your Mini-Com- pact System
To take full advantage of your new
Install the system on a flat, stable surface.
Never place this unit on carpeting.
Never place this unit in an outdoor area.
Maintain an open space of approximately 6 inches (15 cm) on the sides and rear of the system, for ventilation purposes.
Make sure that you have enough room to open the compact disc compartment easily.
Place the loudspeakers at a reasonable distance on either side of the system to ensure good stereo sound.
Direct the loudspeakers towards the listening area.
For optimum performance, make sure that both speakers are placed at an equal distance above the floor.
Connecting your System to the Power Supply
The main lead must be plugged into an appropriate socket.
Before plugging your system into a main socket, you must check the voltage setting (OPTIONAL). If the voltage of the socket does not correspond to the setting on the rear of the unit, you may seriously damage your system.
1 Plug the main lead (marked AC Cord on the rear of the system) into an appropriate socket.
2 Press the STANDBY/ON button to switch your
CD Digital Out Jack (option)
This unit can output CD digital sound signals through this jack. Use an optical cable to connect digital audio equipment. (DAT deck, MD recorder, etc.).
Remove the dust cap (1) from the CD DIGITAL OUT jack. Then, connect an optical cable plug to the CD DIGITAL OUT jack.
(1)
When the CD DIGITAL OUT jack is not being used Attach the supplied dust cap.
6