Inserting Remote Control Batteries
Insert or replace remote control batteries when you:
Purchase the
Find that the remote control is no longer operating correctly
When replacing the batteries, use a new set of batteries and never mix alkaline and manganese batteries.
1 Place your thumb on the position marked 
on the battery compart- ment cover (rear of the remote control) and push the cover in the direction of the arrow.
2 Insert two AAA, LR03 or equivalent batteries, taking care to respect the polarities:
+ on the battery against + on the remote control
– on the battery against - on the remote control
3 Replace the cover by sliding it back until it clicks into position.
Demo/Dimmer function
All functions available on the system can be viewed on the display and the display's brightness can be switched between "on" and "off".
1 | Press the Demo/Dimmer button. |
| Result: All functions available on the system appear on the front |
| panel display. |
| Each of these are explained in detail in this guide. Please refer to |
| the relevant section. |
2 | Press the Demo/Dimmer button again. |
| Result: The Dimmer function is selected and the display darkens. |
3 | Press the Demo/Dimmer button once again to brighten the front |
| panel display. |
A display brightness control can only be performed while the system power is on.
Setting the Clock
GB
Your system is equipped with a clock which allows you to turn your system on and off automatically. You should set the clock:
When you purchase the
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the required options. If you exceed this time, you must start again.
1 | Switch the system on by pressing Standby/on. | |
2 | Press Timer/Clock twice. |
|
| Result: CLOCK is displayed. |
|
3 | Press Enter. |
|
| Result: The hour flashes. |
|
4 |
|
|
To... | Press the... | |
| Increase the hours | Tuning Up |
| Decrease the hours | Tuning Down |
5 | When the correct hour is displayed, press Enter. | |
| Result: The minutes flash. |
|
6 |
|
|
To... | Press the... | |
| Increase the minutes | Tuning Up |
| Decrease the minutes | Tuning Down |
7 | When the correct time is displayed, press Enter. | |
| Result: The clock starts and is displayed, even when the system is in | |
standby mode.
You can display the time, even when you are using another function, by pressing Timer/Clock once.
You can also use Program/Set button on the remote control to instead Enter button in step 3,5,7.
1 |
|
2 | 3,5,7 |
| |
4,6 | 4,6 |
9