Samsung MM-C8Q/XFO Connecting to an External Source, Speaker Connection, Connecting the FM Aerial

Example: You can watch a film and take advantage of stereo sound provided that the original sound track is in stereo (as if you were in a cinema).

CD Digital Out Jack

This unit can output CD digital sound signals through this jack. Use an optical cable to connect digital audio equipment.

(DAT deck, MD recorder, etc.).

Remove the dust cap (1) from the CD DIGITAL OUT jack.

Then, connect an optical cable plug to the CD DIGITAL OUT jack.

(1)

When the CD DIGITAL OUT jack is not being used. Attach the supplied dust cap.

8

Switch the external source on.

Plug the system back into the main socket and press ( switch it on.

) to

3

4 Select the AUX source by pressing AUX. Result: AUX is displayed.

5

For optimum sound quality, do not invert the right and left channels.

Connect the...

Red jack White jack

1

2

Connecting to an External Source

B

The auxiliary input can be used to take advantage of the sound quality of your micro component system when listening to other sources.

Examples: A television

A video disc player

A Hi-Fi stereo video cassette recorder

To connect to the external source, the source must have an audio output. In addition, you need an RCA connection cable.

Set the system to standby mode and disconnect it and the external source from the main socket.

Connect the audio cable to the rear of the micro component system.

To the connector marked...

R (right)

L (left)

Speaker Connection

Main Speaker Connection: Connect the Speaker cords

(red/black) to the Main Speaker jacks of System.

Red wire to the + terminals

Black wire to the – terminals

(Right Speaker) (Left Speaker)

(+) (-) (+) (-)

Connecting the AM (MW)/LW Aerial

GB

The AM aerial (for long and medium waves) can be:

Placed on a stable surface

Fixed to the wall (you must first remove the base)

The AM aerial connector terminals are located on the rear of the system and are marked AM ANT.

To avoid noise interference, check that the loudspeaker wires do not run close to the aerial wires.

Always keep them at least 2 inches (5 cm) away.

Connecting the FM Aerial

How to connect a COAXIAL TYPE aerial.

Connect a 75Ω antenna to the FM antenna terminal.

Plug the connector on the FM aerial supplied into the coaxial socket (75Ω) marked FM on the rear of the system.

Directions in Installing Speaker

Installation in a place near heating apparatus, under direct lay of light or with high humidity may cause performance degradation of the speaker.

Do not install on the wall or on a high place of pole or other unstable place to prevent any safety accident caused by falling of the speaker.

Do not take the speaker apart from TV or computer monitor. The speaker near the TV or computer monitor may influence the quality of the screen display.

Follow the instructions given on Page 15 to tune into a radio station, and determine the best position for the aerial.

If reception is poor, you may need to install an outdoor aerial.

To do so, connect an outdoor FM aerial to the FM socket on the rear of the system using a 75Ω coaxial cable (not supplied).

9