Samsung SMO-120P/UMG manual Alarm Menu Function setting, English-37

3-6) ALARM MENU Function setting

•Function: Allows users to set the ALARM MODE for each camera.

•Setting method: Move to #6. ALARM MENU by using œENTER√ SWITCH at SETUP MENU, and press the ENTER SWITCH to display the OSD as shown in the figure below. (The figure shows the initial setting status.)

06/01/03			13:14:00
	ALARM	SETTING
	CAM1		ON
	CAM2		ON
	CAM3		ON
	CAM4		ON
	CAM5		ON
	CAM6		ON
	CAM7		ON
	CAM8		ON
	HOLD TIME		05SEC
	ALARM ON TIME		00:00
	ALARM OFF TIME		00:00
	BUZZER		ON

(1)CAM1 to CAM8 item sets whether the alarm sensor connected to the camera is used or not. (ON: Alarm function setting, OFF: Alarm function canceling)

(2)HOLD TIME item sets time to freeze alarm operation when alarm occuring. (HOLD TIME to be set: 05SEC ~ 1MIN ~ 30MIN)

(3)ALARM ON/OFF TIME item sets beginning time (ON) and end time (OFF) that monitor recognizes alarm operation as alarm event.

*Note :Even if CAMERA ALARM is set to ON, alarm operation is not carried at time band except pre-set ALARM ON/OFF TIME.

(4)BUZZER item sets whether or not buzzer device set in monitor is used at an ALARM or LOSS occurring.

(ON: Buzzer operation, OFF: NA)

English-37