To set the system time
1.Select a desired address in <Address> or select <Synchronize with PC viewer>.
2.If you select Manual, input the date and time manually.
3.Click [Apply].
The specifi ed system time will be applied.
M <NTP Server IP> is provided by a public agency, the list of which is subject to change from time to time.
In a local network, a separate NTP server must be manually defined.
J The current time can vary depending on the computers regional (GMT and DST) and country (PC time configuration) settings.
To check the log information
Select <System> - <Log>.
The Log information list appears.
ySystem log list : Shows the log information about the system changes along with time and IP address.
-System started: When the camera turns on
-User login: When the user logs in to the camera
-System restarted: When the camera restarts
-Network is up: When accessing the network
-Network is down: When not accessing the network
-Video param. changed: When the video related parameters are changed
-System time changed: When the system time is changed
-Network confi guration change: When the network related confi gurations are changed
-Alarm occurrence 1, 2: When an alarm is generated
-Intelligent Video Analysis occurrence: When an intelligent video analysis event is generated.
-FTP send error: When FTP transfer failed
-SMTP send error: When sending
M | The maximum of 2000 logs can be recorded. |
| If the log number is over 2000, the log in the bottom of the log list will be replaced with a new log. |
● SETUP SCREEN