Heating You Room
Option |
You must select the Heat mode if you wish to adjust the:
◆Heating temperature
◆Fan speed when heating
◆Auxiliary Heater (option)
1 If necessary, press the ON/OFF( |
| ) button. |
|
Result: ◆ The power indicator on the control panel comes on.
◆The indoor unit beeps twice.
◆The operation mode previously set is displayed.
◆The air conditioner starts up in the mode selected when the unit was last used.
IMPORTANTE The air conditioner is fitted with a protection mechanism
to prevent the unit from being damaged when it is started immediately after being:
◆Switched on
◆Stopped
It will start up normally after a
2If the HEAT indicator is not displayed, press the MODE button one or more times until it appears.
Result: ◆ The indoor unit beeps each time you press MODE.
◆The air conditioner starts up in HEAT mode.
To operate the unit by remote control, press the HEAT button.
Note You can change at any time.
3If the “SET TEMP” and “TEMP” indicators are not displayed, press the TIME/TEMP. SELECT button to appear it.
4 | To adjust the temperature, press the TIME/TEMP. | ▲ or | ▼ buttons |
| one or more times until the required temperature is displayed. |
|
|
|
|
| |
| Possible temperature are between 16°C and 30°C inclusive. |
| |
| Result: ◆ Each time you press the TIME/TEMP. | ▲ or | ▼ |
-The temperature is adjusted by 1°C
-The indoor unit beeps.
◆The air conditioner starts heating, provided that
the room temperature is lower than the desired temperature; the fan will, however,operate.
◆ During heating, the operating indicator ( | ) on the control | |
panel comes on. |
|
|
◆ During defrosting, the defrosting indicator ( | ) on the control | |
panel comes on. |
|
|
5Select the fan speed by pressing the FAN SPEED button one or more times until the required setting is displayed:
Low
|
| Medium |
|
|
|
| High |
|
|
| To select | fan speed by remote control, press LOW, MID or HIGH buttons. | ||
| Result: | ◆ Each time you press FAN SPEED, the indoor unit beeps. | ||
|
| ◆ For the first three to five minutes, the fan operates very slowly | ||
|
| unit the air has been sufficiently warmed. | ||
|
| once the correct temperature has been reached, the fan is | ||
|
| automatically set to the required speed. | ||
6 | To control the direction of the air flow refer to page 15. | |||
7 | If you find that the room is not warm enough, set the Auxiliary Heater | |||
| switch to the ON position. (option) |
|
| |
| See ‘Operating Recommendations’ on page 17 for more information. | |||
Result: | ◆ The heater indicator( | ) on | the control panel comes on. | |
|
|
|
| |