Samsung RL39WBSM1/XEG manual Removing and Cleaning the Accessories, Installing a Regular Bottle

INSTALLING A REGULAR BOTTLE

Press the fixing lever, lift the exclusive water tank upwards, then remove it.

Remove the water supply device from the exclusive water tank, then set the inner groove of the water supply device in a regular mineral water bottle and fix it in position by turning it.

Turn the water supply device over, then fix it in position in the fixing hole.

	• Gurgling sounds may be heard when air enters the water tank from regular mineral water or
Note	beverage bottles.

•Some regular mineral water or beverage bottles may not fit the water supply device, depending on their size.

•If water does not come out satisfactorily when you press the “push” button, press it again.

•Do not use carbonated drinks, such as cola, cider or sodas. When you press the button, the beverage may spurt out due to the pressure of carbonic gas accumulated in the upper part of beverage bottle.

•For better hygiene, beverages with a high sugar content (juice, soft drinks) are not recommended.

•Use bottled mineral water or boiled tap water that does not contain any particles.

12

REMOVING AND CLEANING THE ACCESSORIES

Before cleaning the appliance, you must always switch it off and unplug it from the wall socket.

Do not use a steam cleaner. The hot steam could damage the surface of the appliance or the electrical components, causing a risk of electric shock.

Ice cube maker (optional)

• Hold the knob of ice cube maker, then pull the ice cube maker forward.

• Remove the ice cube maker and rinse it in water.

Ice tray (optional)

•Using the handle, pull the ice tray out as far as it will go, then remove it by lifting it up slightly and pulling it towards you.

Fresh salad drawers

• Pull the salad drawers out as far as it will go, then remove it by lifting it slightly and pulling it towards you.

• Wipe it with a damp cloth.

Bottle guard

• Hold the bottle guard in both hands, then remove it by lifting it slightly and pulling it towards you.

• Wash it in water.

Freezer drawer

• Holding the freezer drawer in both hands, pull it out as far as it will go, then remove it by lifting it up slightly and pulling it towards you.

• Wipe it with a damp cloth.

Transparent, safety glass shelf (optional)

• Remove the shelf, then clean it using water and detergent.

•When replacing the shelves, do not mix up the top, middle and bottom shelves.

	When you remove the tempered glass shelves, load a glass and a trim simultaneously to
Note	prevent from dropping the glass.

Rubber seals

• Clean the rubber seals with a damp cloth and detergent. Use a wooden skewer wrapped in a small cloth to clean in the grooves.

13