2Using "PCoIP"
You should always set the Ethernet Mode to Auto and only use 10 Mbps Full Duplex or 100 Mbps Full Duplex when the other network equipment (i.e., switch) is also configured to operate at 10 Mbps
IPv6 Tab
The IPv6 page lets you enable IPv6 for PCoIP devices connected to your IPv6 network.
z
z
IPv6 is not currently supported by VMware View.
When you make a change to one of the settings on this page, you must reboot your device for the change to take effect.
Figure 2-6: IPv6 Configuration
z
z
z
z
z
Enable IPv6
Enable this field to enable IPv6 for your PCoIP devices.
Link Local Address
This field is automatically populated.
Gateway
Enter the gateway address.
Enable DHCPv6
Enable this field to set up Dynamic Host Configuration Protocol version 6 (DHCPv6) for your device. Primary DNS
The primary DNS IP address of the device. If DHCPv6 is enabled, this field is automatically populated by the DHCPv6 server.
2 Using "PCoIP" 36