Samsung WW10H9400EW/ET manual Adaptor with a clicking sound

6.While holding down part (E), connect the water supply hose to the adaptor. Then, release part (E). The hose fits into the

adaptor with a clicking sound.

E

7.Connect the other end of the water supply hose to the inlet valve on the back of the washing machine. Turn the hose

clockwise to tighten.

8.Open the water tap and check if there are any leaks around the connection areas. If there are water leaks, repeat the steps above.

•If using a screw type of water tap, connect the water hose to the water tap as shown.

WARNING

Stop using the washing machine if there is a water leak, and contact a local Samsung service centre. Otherwise, this may cause electric shock.

CAUTION

Do not stretch the water supply hose by force. If the hose is too short, replace the hose with a longer, high-pressure hose.

•After connecting the water supply hose to the adaptor, check if it is connected properly by pulling the water supply hose downwards.

•Use a popular type of water taps. If the tap is square-shaped or too big, remove the spacer ring before inserting the tap into the adaptor.

English - 16

Untitled-16 16

5/26/2017 3:42:25 PM