A470e Users Guide

Hardware

 

 

 

 

 

Mechanism Model:

 

 

A470E-48X1

Independent Validate

A470E-48X0

Receipt Only

A470E-4812

Concurrent Validate With Rewind

A470E-4872

Concurrent Validate

A470E-4874

Validate Only

The Mechanism Model Option is Not Selectable in Configuration Mode. Setup for this option is done via Command Codes. Setting the mechanism model incorrectly could result in damage to the printer.

Please contact your Pertech service representative if you are unsure of the model your printer should be set to.

LED Usage

Status / Slip

Power / Paper Low

Validation Clamp: (A470 Mode Only).

Closed

Open

Form Insert Wait (ACL Mode Only):

0-15 Minute

Paper Low Sensor:

Enabled

Disabled

Paper Out Sensor

Disabled

Equals Paper Low

Virtual Paper Out

2FT 4FT 6FT 8FT 10FT 12FT

Extended Self Test

At the completion of the Configuration Report Self Test, the printer will prompt for access to the Configuration Mode, let the option for the Configuration Mode expire. The printer will then prompt for the Extended Self Test. To begin the Extended Self Test press the Paper Feed Button within 10 seconds. If the button is not pressed within this time limit, the printer will resume normal operation.

The Extended Self Test performs a printhead pin firing test, character drop test, checks the vertical line adjustments, fonts, validation clamp, pitches and character sets.

Pertech® 2006

16

Page 23
Image 23
Pertech A470e manual Extended Self Test, Hardware