Connections
Connecting to a COMMON INTERFACE slot |
|
Attaching the CI Card Adapter |
|
Attach the adapter as shown below. | TV Rear |
To connect the CI CARD Adapter, follow these steps. |
|
✎✎We recommend attaching the adapter before installing the wall mount, or |
|
inserting the “CI or CI+ CARD.” |
|
1. Insert the CI CARD Adapter into the two holes on the product 1. |
|
✎✎ Please find a two holes on the rear of the TV. A two holes is beside the |
|
COMMON INTERFACE port. |
|
2.Connect the CI CARD Adapter into the COMMON INTERFACE port on the product 2.
3.Insert the “CI or CI+ CARD”.
We recommand that you insert the CI card before you mount the TV on a wall.
It may be difficult to insert | after the | mounting. |
Insert the card after attaching the CI CARD Adapter, on TV. | ||
It is difficult to attach the | module if | you insert the card before attaching. |
Using the “CI or CI+ CARD”
To watch paid channels, the “CI or CI+ CARD” must be inserted.
•• If you don’t insert the “CI or CI+ CARD,” some channels will display the message “Scrambled Signal”.
•• The pairing information containing a telephone number, the “CI or CI+ CARD” ID the Host ID and other information will be displayed in about 2~3 minutes. If an error message is displayed, please contact your service provider.
•• When the configuration of channel information has finished, the message “Updating Completed” is displayed, indicating the channel list is updated.
✎✎NOTE
xx You must obtain a “CI or CI+ CARD” from a local cable service provider.
xx When removing the “CI or CI+ CARD”, carefully pull it out with your hands since dropping the “CI or CI+ CARD” may cause damage to it.
xx Insert the “CI or CI+ CARD” in the direction marked on the card.
xx The location of the COMMON INTERFACE slot may be different depending on the model.
xx “CI or CI+ CARD” is not supported in some countries and regions; check with your authorized dealer. xx If you have any problems, please contact a service provider.
xx Insert the “CI or CI+ CARD” that supports the current antenna settings. The screen will be distorted or will not be seen.