Satellite System

Basic Features

Satellite System is available when Antenna is set to Satellite. Before running Auto Tuning, set Satellite System. Then channel scan is run normally.

•• Satellite Selection: You can choose the satellites for this TV.

•• LNB Power (Off / On): Enables or disables the power supply for the LNB.

•• LNB Settings: Configures the outdoor equipment.

––Satellite: Selects the satellite for receiving digital broadcasts.

––Transponder: Selects a transponder from the list or adds a new transponder.

––DiSEqC Mode: Selects DiSEqC mode for the selected LNB.

––Lower LNB Oscillators: Sets the LNB oscillators to a lower frequency.

––Upper LNB Oscillators: Sets the LNB oscillators to a higher frequency.

––Tone 22 kHz (Off / On / Auto): Selects the Tone 22 kHz depending on the LNB type. For a universal LNB it should be Auto.

––Signal Quality: Display the current status of broadcasting signal.

•• Positioner Settings: Configures the antenna positioner. Positioner (On / Off): Enables or disables the positioned control.

Positioner Type (USALS / DiSEqC 1.2): Sets the positioned type between DiSEqC 1.2 and USALS(Universal Satellite Automatic Location System).

––My Longitude: Sets the longitude for my location.

––My Latitude: Sets the latitude for my location.

––Satellite Longitude Settings: Sets the longitude of user defined satellites.

User Mode: Sets the position of satellite antenna according to each satellite. If you store the current position of satellite antenna according to a certain satellite, when the signal of that satellite is needed, the satellite antenna can be moved to pre-populated position.

––Satellite: Selects the satellite to set the position for.

––Transponder: Selects a transponder from the list for signal reception.

––Moving Mode: Selects the movement mode between discrete and continuous movement.

––Step Size: Adjusts the step size degrees for the antenna rotation. Step Size is available when Moving Mode is set to Step.

––Go To Stored Position: Rotates the antenna to the stored satellite position.

––Aerial Position: Rotate the aerial and store position for this satellite.

––Store Current Position: Stores current position as the selected positioner limit.

––Signal Quality: Display the current status of broadcasting signal.

English - 47