Samsung LT24B301MW/ZR, LT24B301EWY/EN Connections, Connecting to an Antenna, Setup Initial Setup

Connections

Connecting to an Antenna

When the LED display is initially powered on, basic settings proceed automatically. ✎✎Preset: Connecting the mains and antenna.

ANT OUT

Power Input

Setup (Initial Setup)

When the LED display is initially powered on, a sequence of on-screen prompts will assist in configuring basic settings. Press the POWERPbutton. Setup is available only when the Input Source is set to TV.

✎✎Before turning on the LED display, make sure the antenna cable is connected.

1	languageSelecting a menu
2	Selecting Store Demo
	or Home Use

3	Selecting an area
4	Auto Tuning

5 Setting the Clock Mode

6 Complete

Press the uor dbutton to select a menu language. Press ENTEREbutton	P
twice when done.
Press the uor dbutton, then press the ENTEREbutton.

xx Select the Home Use mode. Store Demo Mode is for retail environments.

xx To return the unit’s settings from Store Demo to Home Use (standard): Press the volume button on the LED display. When you see the volume OSD, press and hold MENU for 5 sec.

xx Store Demo is only for shop display. If you select it, several functions are not able to use. Please select Home Use when you watch at home.

Press the ENTEREbutton. Select the appropriate area by pressing the uor dbutton. Press the ENTEREbutton to confirm your choice.

Press the uor dbutton to select correct option, and then press ENTEREbutton twice.

xx I use an aerial cable. Memorise all of the available channels using RF cable. (Auto Tuning necessary)

xx I use a cable or satellite service. You don't need to use Auto Tuning to find channels. ✎✎ You can complete Setup by selecting it.

xx Air / Cable: Select the antenna source to memorise.

Digital & Analogue / Digital / Analogue: Select the channel source to memorise. ✎✎ You can check more details on page22.

Set the Clock Mode automatically or manually.

xx Auto: Select the time zone (depending on the country) where you are located.

xx Manual: Allows you to manually set the current date and time.

✎✎ If the customer chooses "I use a cable or satellite service." in step 4, the clock just can be set manually.

Press the ENTEREbutton.

If You Want to Reset This Feature...

Select System - Setup (Initial Setup). Enter your 4 digit PIN number. The default PIN number is “0-0-0-0”. If you want to change the PIN number, use the Change PIN function.

You should do Setup (MENU → System) again at home although you did in shop.

✎✎If you forget the PIN code, press the remote control buttons in the following sequence in Standby mode, which resets the PIN to “0-0-0-0”: POWER (off) → MUTE → 8 → 2 → 4 → POWER (on).

English 14