6Setup and Reset
6.3DisplayPort Ver.
Select your Displayport. Displayport 1.1 supports High Bit Rate 1, while 1.2 supports High Bit Rate 2.
Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications.
If the monitor (when set to HDMI 1, HDMI 2 or DisplayPort) is in power saving mode or is displaying the message Check Signal Cable, press the [ ] button to display the On Screen Display (OSD). You can select 1.1 or 1.2.
If you select 1.1, the maximum resolution of your screen drops to 2560 x 1440 due to the limitations in HBR1 transmission speeds.
6.3.1 Configuring DisplayPort Ver.
1When the Function Key Guide appears, select [ ] by moving the JOG button UP. Next, press the JOG button.
2Move to Settings controlling the JOG button UP/DOWN and press the JOG button.
3Move to DisplayPort Ver. controlling the JOG button UP/DOWN and press the JOG button. The following screen will appear.
Settings |
| Select your |
|
| |
Eco Saving | Off | Displayport. |
|
| Displayport 1.1 |
PC/AV Mode |
| supports HBR 1, |
| 1.1 | while 1.2 supports |
DisplayPort Ver. | HBR 2. | |
Source Detection | 1.2 |
|
Key Repeat Time |
|
|
Off Timer |
|
|
Power LED On |
|
1.1 / 1.2
4Move to the desired option controlling the JOG button UP/DOWN and press the JOG button.
5The selected option will be applied.
6 Setup and Reset 68