Connections
Wireless Network
You can connect to network with a Wireless IP sharer.
A wireless AP/IP router is required to make a wireless network connection.
Set the network options. (See pages 37~41)
Broadband service
Wireless IP sharer
Networking with PC for AllShare function (See pages 56~57)
✎NOTE
▪To use a wireless network, your product must be connected to a wireless IP sharer. If the wireless IP sharer supports DHCP, your product can use a DHCP or static IP address to connect to the wireless network.
▪This product supports IEEE 802.11B, IEEE 802.11G, IEEE 802.11N. When you play the video over IEEE 802.11B/G connection, the video may not be played smoothly.
▪Select a channel for the wireless IP sharer that is not currently being used. If the channel set for the wireless IP sharer is currently being used by another device nearby, this will result in interference and communication failure.
▪If Pure
▪If your AP supports WPS
▪Connection Methods : You can setup the wireless network connection 3 ways.
-PBC (WPS)
-Auto Setup (Using the Auto Network Search function)
-Manual Setup
▪Wireless LAN, by its nature, may cause interference, depending on the use condition (AP performance, distance, obstacles, interference by other radio devices, etc).
▪Set the wireless IP sharer to Infrastructure mode.
▪When applying the security key for the AP (wireless IP sharer), only the following is supported. 1) Authentication Mode : WEP, WPAPSK, WPA2PSK
2) Encryption Type : WEP, AES
▪For the AllShare function, a PC must be connected in the network as shown in the figure.
28 English