Wired Network

Setup

1.In the Network Settings menu, press the ▲▼ buttons to select Network Settings, and then press the ENTER button.

The Internet Protocol Setup screen appears.

2.Press the ► button, then select Auto or Manual, and then press the ENTER button.

Setting Up a Wired Connection - Auto

1.If you selected Auto, the Network Function acquires and fills in the values for IP Address, Subnet Mask, etc., automatically.

✎NOTE

▪ This process can take up to five minutes.

Settings

Display		Network Settings
	Internet Protocol Setup		: Auto
Audio					0	0	\
System		IP Address	:	0			0
		Subnet Mask	:	0	0	0	0
Network
Language Gateway			:	0	0	0	0
	DNS		: Auto
Security		DNS Server	:	0	0	0	0
General
Support		> Move		" Select		' Return

2.After the Network Function has acquired the network values, press the RETURN button. Then, run a Network Test to ensure the product has connected to your network (See page 41).

3.If the Network Function does not acquire the network values or you selected Manual, go to the directions for Manual Setup.

Setting Up a Wired Connection - Manual

If the Auto Setting does not work, you’ll need to set the Network Setting values manually.

To get the Network setting values from most Windows computers, follow these steps:

1.Right click the Network icon on the bottom right of the screen.

2.In the pop-up menu, click Status.

3.On the dialog that appears, click the Support tab.

4.On the Support tab, click the Details button. The Network settings are displayed.

To enter the Network settings into your product, follow these steps:

1.On the Internet Protocol Setup screen, press the ENTER button.

2.Press the ▲▼ buttons to select Manual, and then press the ENTER button.

3.Press the ▼ button to go to the first entry field (IP Address).

Settings

Display		Network Settings
	Internet Protocol Setup		: Manual
Audio						0	\
System		IP Address	:	0	0		0
		Subnet Mask	:	255	255	255	0
Network
Language Gateway			:	0	0	0	0
	DNS		: Manual
Security		DNS Server	:	0	0	0	0
General
Support		> Move		" Select		' Return

Select to configure your network type and IP address, or to perform a Network Test.

4.Use the number buttons on your remote to enter numbers.

5.When done with each field, use the ► button to move successively to the next field.

You can also use the other arrow buttons to move up, down, and back.

6.Enter the IP Address, Subnet Mask, and Gateway values.

7.Press the ▼ button to go to DNS.

8.Press the ▼ button to go to the first DNS entry field. Enter the numbers as above.

38 English