Samsung SCQ-041AP manual SCQ-041P Installation, Configuration for Installation

Page 20

User’s Guide

Chapter 2, SCQ-041P Installation

Configuration for Installation

This chapter describes the configuration required for the safe installation and usage of the SCQ-041P.

You can install the SCQ-041P on flat table or rack. This system must be in horizontal balance and should not be placed on a vertical or slide setting. The location of the main board and the configuration of the wire unit component are very important to operate the system properly. If the components are so close that ventilation is not sufficient, the system may not work properly or will be difficult to maintain. To reduce risk leading to system malfunction or shutdown as a result of configuration, please make sure to allow enough ventilation in the system operating room and fix the cover of main unit firmly. High-voltage current occurs in the unit; therefore, please do not try to open the cover.

The SCQ-041P requires the following operating conditions to maintain temperature and humidity.

• Operating temperature

: 32 - 86°F (0 - 40°C)

• Relative humidity

: 30% - 90% relative humidity

• Input voltage

: AC 100V-240V

• Power of consumption

: 10 Watts

• Frequency

: 50 Hz/60 Hz

CAUTION

Please supply input power voltage with a variation of less than 10% of the specific voltage to the system in use. The power plug must be grounded. Please do not connect other appliances or equipment using the system’s power outlet. It is recommended to use AVR to supply a stable power source. If you would use this appliance to supply voltage for 240V, you should be used the proper plug adapter for 240V rating.

8

Image 20
Contents SCQ-041P Page Safety Precautions Important Safeguards Page User’s Guide Vii Prior to Use Structure of User’s Guide Detecting Channel Loss Describes how to detect Contents Xii SCQ-041P Overview OverviewFeatures and Characteristics Part Names and Features SCQ-041P Front ViewFREEZE-1 Setup Back of SCQ-041P ~AC SCQ-041P Installation Configuration for InstallationSCQ-041P Main Unit USER’S Guide Power Cable 1 EA UnpackingMounting the SCQ-041P in a Rack 041PChapter Chapter Connecting Other Components Connecting a CameraConnecting a VCR Connecting a Monitor Connecting an Alarm Connecting External ComponentsConfiguring the SCQ-041P Main MenuChannel Title Setting Channel Title SETUser’s Guide Date/Time Setting DATE/TIME SETDisplay Mode Setting Display Mode SETAlarm Setting What is TTL level? TTL level LOW 0V ~ TTL level High Auto Switcher Setting Loss Detect Setting Operating the Alarm Alarm Input/Output Terminal SpecificationAlarm Signal Mode Viewing the Alarm List ALARM/LOSS ListSearching for Alarm Operation Information Situations in which the Alarm is in UseDisabling the Alarm Channel Loss Search in Each Mode Detecting Channel LossRestoring to Normal Mode Appendix A, SCQ-041P Specifications SpecificationsWeight External Components 350 mm 430 mmAppendix B Remote Control Connector Table PIN no Control Items FunctionRS-232C Table Terminal componentsAppendix C, Troubleshooting