Samsung WF520ABP/XAA manual Please remove the device and connect

troubleshooting

Error Image	MEANING	SOLUTION
	Your washer has tried to fill but was	Make sure the water faucets are open
	unsuccessful.	all the way. Check for kinked hoses.
		Check the inlet screens on the fill
		hoses.
		If you use a Flood Safety Device, then
Low Water Pressure		please remove the device and connect
		the water hoses directly to the unit.
	Check if the hot water supply hose is	You must connect the hot water supply
	connected.	hose because hot water is supplied by
		the Auto Temperature Control (A.T.C.)
		function if the temperature of the cold
		water is lower than 59°F.
Water Temperature Control	The hot/cold water hose connection is	Please connect the hot/cold water
	not correct.	hose connection correctly.
Problem
Power Interruption	Problem with control.	Call for service.
Water Supply Problem	A fault is detected in the water level	Call for service
	sensor.
A Button is either stuck or is	Jammed key.	Call for service
being pressed continuouly.
The Motor is not working	Motor problem	Restart the cycle
		If the code reappears, call for service
properly.
Temperature Sensor	Temperature sensor problem.	Restart the cycle.
Problem		If the code reappears, call for service.
High/Low Voltage Detected	High/Low voltage detected.	Restart the cycle.
		If the code reappears, call for service.
Electronic Control Problem	Communication error between SUB	Call for service
	PBA and MAIN PBA
Front MEMS Sensor Problem	Front MEMS sensor problem	Call for service
Rear MEMS Sensor Problem	Rear MEMS sensor problem	Call for service
	Too many suds are detected during the	To prevent it, cut down on detergents.
	washing session.
	The unit is put on hold until the suds
Excessive Suds	are reduced. Then, the unit will go back
	to the operation.

When it finishes washing, “End” and “Excessive Suds” codes will blink in turn.

For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG)

36_ troubleshooting

WF520AB-02838A-02_EN.indd 36

2010-09-01 �� 4:06:08