Installing Your Microwave Oven

EN	This microwave oven can be placed almost anywhere (kitchen work
EN	surface or shelf, movable trolley, table).
			For your personal safety, this appliance must be:
			• Properly earthed (3-pin plug)
			• Plugged into a standard 230 Volt, 50 Hz, AC earthed socket
	1.	Install the oven on a flat, level, stable surface. Make sure there is adequate
		ventilation for your oven by leaving at least 10cm(four inches) of space
		behind, on the sides of the oven and 20cm(eight inches) of above.
		(For stacking see page 10.)
	2.	Never block the air vents as the oven may overheat and automatically switch
		itself off. It will remain inoperable until it has cooled sufficiently.
	3.	Remove all packing materials inside the oven.
	4.	Plug the cable into a 3-pin, earthed socket. If the power cable of this appliance
		is damaged, it must be replaced by a special cable as supplied from service
		center.
			Be sure to remove the protective film from outer case. The
			protective film is on the outer case to prevent scratches. When
			installing or before using, be sure to remove it.

Outdoor Use

This microwave oven is not designed for outdoor use.

You should use it indoors only.

During Air Cooling

Do not turn power off while the cooling fan is automatically air-cooling for 1min.

Recommendations

DO NOT install the microwave oven in hot or damp surroundings. Example: Next to a traditional oven or radiator.

The power supply specifications of the oven must be respected and any extension cable used must be of the same standard as the power cable supplied with the oven.

Wipe the interior and the door seal with a damp cloth before using your microwave oven for the first time.

Cooking / Reheating

Make sure the oven is plugged into a properly earthed electrical outlet and “ON” appears in the display window.

Open the door(The oven lamp will be turned on.).

Put the food into a suitable container, place it in the centre of the oven and then close the door securely (The oven lamp will go off.).

1. Select the desired power level by rotating the COOKING POWER CONTROL DIAL.

Result : The selected power level will be displayed in the display window.

2.Set the desired heating time by rotating the TIMER DIAL.

Result : “ON” blinks and the selected time is displayed in the display window.

3.Press button:

Result : The oven lamp and cooling fan will be turned on. Heating will start.

The time on digital display will count down.

When all time is elapsed, the end of cycle Beep Tone will sound 4 times and all heating will stop. The oven lamp will go off. For 1 min, the display shows ‘0‘ and the cooling fan will keep working in order to cool down the interior parts.

During the time, the fan will not stop even when you open the door. 1 min later it will stop and “ON” appears again. Food may be removed from oven whilst the fan is still running.

4.Open the door and take the food out. Close the door. The oven lamp will go off.