Connecting to the Water Supply | Samsung DM-B58AHC/XET manual

EN		2 / INSTALLING YOUR DISHWASHER

• CONNECTING TO THE WATER SUPPLY

This dishwasher can be supplied with cold water or hot water up to a maximum of 60°C. When supplying with hot water, check that your original hose allows such connection (red marking on the hose). However, we recommend that you connect to the cold water supply. Your appliance is fitted with a supply hose 1.50m long.

Connect the hose to a tap with a threaded end, diameter 20/27 (3/4" BSP).

Check that the water pressure does not exceed the values below:

Flow rate: 10 L/min (1 L/min minimum)

Pressure: 1 to 10 bars (0.1 - 1 MPa) A .

If the water pressure is too high, please fit a pressure regulator. Please contact your local Water Authority for advice on the water pres- sure in your region.

Warning:

If you use a self-piercing tap, check that there is sufficient water flow.

Check that the hose seal is present and that the connection is tight C .

Do not re-use any previously used hoses for making the connection.

Avoid any kinks or constrictions in the hose, which could prevent the water from passing or slow down its flow, particularly when buil- ding in the appliance under the worktop B .

If the appliance is connected to new pipes or pipes that have not been used for a certain length of time, let the water run for a few minutes before connecting the water hose to avoid and deposits of sand or rust that could block the water hose’s filter.

0,1 - 1 MPa

10L/min

Danger:

The symbol indicates that the hose is fitted with an electrical device for cutting off the water supply (depending on the model). Do not leave this hose in water and do not cut it.

NB:

Any connection to a water conduit necessarily involves the risk of a leak occur- ring, whatever the precautions taken. Therefore, always close the water tap when you are not using your machine.