Samsung HT-D350K/UM, HT-D350K/ZN Installing the Speakers on the Half Tallboy Stand, English 1

Installing the Speakers on the Half Tallboy Stand

02

*HT-D353HK only - Front Speakers

1.Stretch out the speaker cable and arrange it through the hole of the stand base as shown.

2.Tighten the stand nut (C) as shown and use the stand screwdriver (D) to tighten it in the arrow direction.

3.This is after the speaker is installed completely. Tighten the other speakers in the same manner.

1 2

3

Conne

Installing the Speakers on the Tallboy Sta

*HT-D355K only - Front/Surround Speakers

1.Turn the Stand Base upside-down and connect it to the Stand.

2.Insert small screws (4*20, For connecting Stand & Stand Base) clockwise into the four holes marked using a screwdriver as shown in the illustration.

!CAUTION : When you use a torque screwdriver, be careful not to put excessive force. Otherwise, it runs idle or can be damaged. (torque screwdriver- below 15 kg.f.cm)

3.Connect the upper Speaker to the assembled Stand.

4.Insert another large screw (5*15, For connecting Speaker & Stand) clockwise into the hole on the rear of the speaker using a screwdriver.

5.This is the appearance after the speaker is installed. Follow this steps to install other speaker.

1

Stand

Base

Stand

3

Speaker

Stand

5

2

4

Adjusting the height of the Half Tallboy Speaker

* HT-D353HK only - Front Speakers

1. If you want to change the speaker position (height),	1
remove two screws in the rear side.

2. Pull up the speaker in the arrow direction as shown. (See fi gure 2)

! CAUTION : Do not apply excessive force. Otherwise, it may cause a physical injury.

2

English 1