Samsung GN952IFXA/XET, GN642FFXA/XET, GN792IFXA/XET How to turn on Turn on, Flame failure device

Page 15

3.3 How to turn on

Turn on

Each burner can be adjusted steplessly between the full and low positions.

Burner indication 0-setting

High setting

Low setting

Open the main gas valve (only by first use).

Place a pot or a pan on the corresponding cooking position.

Press the control knob and turn it counterclockwise to ignite the burner. The burner ignites.

Flame failure device

The flame failure device ensures that the gas supply shuts off if the flame goes out during the cooking process.

Hold the control knob pressed in the high setting for approximately 5 seconds to switch on the flame failure device.

Dirty igniters make it harder to ignite the burner, so you should keep them as

clean as possible. Clean them with a small brush and make sure you do not hit or knock the ignition device violently.

The flame failure should not be operated for more than 15 seconds. If the burner does not light after 15 seconds, stop operating the device and open the compartment door and/or wait at least 1 minute better attempting to ignite the burner again.

In the event that the burner flames are accidently extinguished, turn off the

burner control and do not attempt to re-ignite the burner for at least 1 minute.

GB 15

Image 15
Contents GN642FFXA GN792IFXA GN952IFXA Preface Safety warning ContentPreface Safety warning Below signs have the following meaningIf you think gas is leaking, proceed as follows Installation Warning Child and people safety Warning During use During use During use During use Caution Environmental information Cleaning & service WarningDescription of the appliance KnobBurner GN952IFXA / GN952IFXABChoose the burner properly for usage How to use the appliance BurnerFlame failure device How to turn on Turn onHow to turn off Turn off Safety and energy saving advice General Cleaning and maintenanceTop plate Pan support, control knobsCleaning and maintenance Burners Cleaning and maintenance Burners Problem Cause Solution TroubleshootingCustomer Care Web Site FAX no Address Remark Center TEL Application for serviceTechnical instructions Technical data for engineers Appliance specificationsAppliance class Class Appliance category II2L3B/P Cutout size PositioningSpace to be left free around the appliance ISO Installing the applianceGas supplied by tank or cylinder butane/propane Gas connectionElectrical connection Gas conversion
Related manuals
Manual 30 pages 48.79 Kb Manual 29 pages 24.13 Kb