Samsung NZ63K7777BK/ET manual Installing into the countertop

Installing into the countertop

01 02

A

NOTE

Make a note of the serial number on the appliance rating label prior to installation.

06

03

This number will be required in the case of requests for service and is no longer accessible after installation, as it is on the original rating plate on the underside of the appliance.

04 07

05

09

08 11

1012

A.Serial number

NOTE

No. Explanation Size

Installing

Pay special attention to the minimum space and clearance requirements.

NOTE

The bottom of the hob is equipped with a fan. If there is a drawer under the hob it should not be used to store small objects or paper, since they could damage the fan or interfere with the cooling if they are sucked into it.

01	Check 4 Point
02	Drill diameter	Ø 6
03	Right angle of cutting point	90 °
04	Cutting Width Size	560±1 mm
05	Cutting Depth Size	490±1 mm
06	Curve Size	R3

the hob

01

02

No.	Explanation	Size
01	Height of	Min 2 mm
	ventilation hole
02	Width of	560 mm
	ventilation hole

07	Size of table thickness	Max 50 mm,
		Min 20 mm
08	Distance between end of table and cutting point	Min 60 mm
	(Rear-side)
09	Depth of table	Min 600 mm
10	Distance between end of table and cutting point	Min 60 mm
	(Left-side)
11	Distance between end of table and cutting point	Min 60 mm
	(Right-side)
12	Distance between end of table and cutting point	Min 50 mm
	(Front-side)
		English  9

NZ63K7777BK_ET_DG68-00803A-00_EN.indd 9

3/30/2016 4:45:40 PM