Samsung GN642FFXD/XET, GN642FFXD/XEU manual Gas Conversion, Change the injector of the burners

24

Gas Conversion

■ Be careful, the operations and adjustments to be carried out when converting from one gas to another.

■ All work must be carried out by a qualified technician.

■ Before you begin, turn off the gas and electricity supply to the appliance.

1 Change the injector of the burners.

		Remove the pan support, Burner lid and Flame spreader.
		Unscrew the injector using a 7mm box spanner and replace it with
		the stipulated injector for new gas supply. ( see table 1. Page 25.)
		Carefully reassemble the all components.
		After injectors are replaced, it is advisable to strongly tighten the
2	Injector	injector in place.
	Adjusting of the taps of the cooking hob burners for
	reduced consumption
		➀ Turn the taps down to minimum.

Control handle	➁ Remove the control handles from taps.
	➂ Adjusting the by-pass screw.

Tap Sealing ring

Tap

by-pass screw

-For converting G20 into G30 or G31, the screw must be screwed down fully tight.

-At this stage, light up the burners and turn the control handles from max position to minimum position to check flame stability.

-For converting G30 or G31 into G20, please contact “After-Sales Service”.

➃Replace the control handles on the taps.

■Do not dismantle the tap shaft : in the event of a malfunction, change the whole tap.

■Before placing the burners back on the top place, make sure that the injector is not blocked.

■A full operational test and a test for possible leakages must be carried out after gas conversion. (such as soap water or gas detector)

■After completing conversion, a qualified technician or installer has to mark “V”

on the right gas category
to match with the setting				0063
in rating plate.
Remove the previous	GN641FFBD	S/N: A36579MZ400007A
	G20/20mbar	220-240V 50/60Hz, Pmax 1W
setting “V” mark.
	∑Qn Q20: 7.5kW G30: 521g/h G31: 503g/h
	G20-20mbar	G30/29mbar	G31/37mbar		GB Cat.: ll 2H3+