MENU | DESCRIPTION |
|
|
Network | By connecting a LAN cable between the PC and projector, you can use the following supplementary |
| functions on your PC. |
| On your PC, you can check the projector's conditions (LED runtime, operation error,temperature) and |
| remotely control the projector's power On/Off, brightness, and sound On/Off. |
| <Network> : <On> - <Off> |
| <IP Setting> |
•<Automatic> : Automatically allots the IP address, Subnet mask and Gateway.
•<Manual> : Allows you to manually enter the IP address, Subnet mask and Gateway manually.
After pressing the [ 
] button to enter values, change the values using the 
/ 
buttons and move using the 
/
buttons. Once the values are filled in, press the[
] button.
| <Server IP Setting> : Allows you to enter the server PC's IP address. |
| To use the network function, <Network> must be set to <On>. |
| If the network connection fails, enter the IP address of the server PC under <Server IP Setting>. |
|
|
Reset | Using this function, you can reset various settings to the factory default settings. |
| • <Factory Default> : Changes the settings to the factory defaults. |
| • <Media Play> : The following functions are activated only when the projector fails to enter the |
| <Media Play> mode due to a <Media Play> mode error. (Only for |
Activated only in <Media Play> Mode.
•<Recovery Mode>: When the projector is turned off during a firmware update, use this function to continue the update.
• <OK> - <Cancel>
Under normal usage, update by selecting <Setup>→<Update/Reset>→<Firmware
Update> in the <Media Play> menu.
•<System Reset>: When the <Media Play> operation suddenly freezes, use this function to restart <Media Play>.
• <OK> - <Cancel>
Using |