Solving Common Problems, When you press Button

Solving Common Problems

Before contacting the after-sales service, perform the following simple checks. They may save you the time and expense of an unnecessary call.

Explanation/Solution

Check that the breaker used for the air conditioner is switched on. Check that the operation indicator on the indoor unit is on;

if necessary press the button on the remote control.

Check whether the Timer indicator on the indoor unit is switched on. If so:

-Wait until the switch-on time is reached and the air conditioner starts up automatically

-Cancel the timer (see pages 16 and 17 for further details)

The air conditioner does not operate with the remote control

Check that there are no obstacles between you and the indoor unit. Check the remote control batteries.

Check that you are close enough to the indoor unit (seven meters/yards or less).

No beep is heard when you press

the on the remote control

Check that you are pointing the remote control at the remote control sensor in the right of the indoor unit.

Replace the remote control batteries if necessary.

The air conditioner does not cool Check that the correct operating mode has been selected

or heat(Auto, Cool, Heat).

The room temperature may be too low or too high.

Dust may be blocking the air ﬁlter guard; refer to page 23 for cleaning instructions.

Check that there is no obstacle in front of the outdoor unit.

When heating, the required room temperature is never reached and the air conditioner frequently stops

Check that the required temperature has been set correctly. Increase the fan speed.

If the air ﬂow is directed upwards, use the remote control to direct it downwards.

The fan speed does not change		Check that the operating mode is set to the Auto, Cool, Heat or Fan
when you press the	button	mode ; in the Dry mode, the fan speed changes automatically.

The air ﬂow direction does not Check that the air conditioner has been switched on; if necessary,

change when you press the press the button on the remote control. button

The timer is not correctly triggered Check that the timer has been programmed correctly; see pages 16 and 17.

Odour is permeated in the room Air the room. during air conditioning

E-22

DB98-28642A(1)-E.indd 22

2007-10-27 13:32:17