Cooling Your Room
You must select the Cool mode if you wish to adjust the: Cooling temperature
Fan speed when cooling
1If necessary, press the 
button.
Result: The operation indicator on the indoor unit lights up. The air conditioner starts up in the mode selected
when the unit was last used. The indoor unit beeps.
IMPORTANT The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started
immediately after being: Plugged in Stopped
lt will start up normally after three minutes.
2If the 
is not displayed at the top of the remote control,
press the 
button on the remote control one or more times until it appears.
Result: The indoor unit beeps each time you press the 
button.
The air conditioner runs in the Cool mode.
Note You can change modes at any time.
3To adjust the temperature, press the 
button one or more times until the required temperature is displayed.
Possible temperatures are between 16°C and 30°C inclusive.
Result: | Each time you press the | button: |
-The temperature is adjusted by 1°C
-The indoor unit beeps
The air conditioner starts cooling, provided that the room temperature is higher than the selected temperature.
If the room temperature reaches the set temperature, the air conditioner stops cooling, but the fan is still operating.
4Select the fan speed by pressing the 
button one or more times until the required setting is displayed:
Automatic (rotated : 
)
Low
Medium
High
Maximum
Result: | Each time you press the | button, the indoor unit beeps. |
5To control the direction of the air flow, refer to pages 14 and 15.
ENGLISH