Heating Your Room
You must select the Heat mode if you wish to adjust the: Heating temperature
Fan speed when Heating
1 If necessary, press the 
button.
Result: The operation indicator on the indoor unit lights up. The air conditioner starts up in the mode selected
when the unit was last used. The indoor unit beeps.
IMPORTANT | The air conditioner is fitted with a protection mechanism |
| to prevent the unit from being damaged when it is started |
| immediately after being: |
| Plugged in |
| Stopped |
| lt will start up normally after three minutes. |
2If the 
is not displayed at the top of the remote control,
press the 
button on the remote control one or more times until it appears.
Result: The indoor unit beeps each time you press the 
button.
The air conditioner runs in the Heat mode.
Note You can change modes at any time.
3To adjust the temperature, press the 
button one or more times until the required temperature is displayed.
Possible temperatures are between 16°C and 30°C inclusive.
Result: | Each time you press the | button: |
- The temperature is adjusted by 1°C - The indoor unit beeps
If the room temperature reaches the set temperature (selected temperature+5°C), the air conditioner stops heating, but the fan is still operating.
The air conditioner starts heating, provided that the room temperature is lower than the desired temperature (selected temperature+3°C).
4Select the fan speed by pressing the 
button one or more times until the required setting is displayed:
Automatic (rotated : 
)
Low
Medium
High
Maximum
Result: Each time you press the 
button, the indoor unit beeps. For the first three to five minutes, the fan operates very
slowly until the air has been sufficiently warmed. Once the correct temperature has been reached, the fan is automatically set to the required speed.