Samsung DVD-R135/UMG manual Connecting HDMI/DVI to a, Case 1 Connecting to a TV with Hdmi Jack

Page 21

Connecting HDMI/DVI to a

TV

If your TV has a HDMI/DVI input, connect the HDMI/DVI cable to the TV. You will enjoy the best quality images and sounds.

● Case 1 : Connecting to a TV with HDMI Jack

● Case 2 : Connecting to a TV with DVI Jack

Case 1 : Connecting to a TV with HDMI Jack

●Using the HDMI cable, connect the HDMI OUT jack on the rear of the DVD Recorder to the HDMI IN jack

 

of your TV.

 

■

To change HDMI output resolution, see page 33.

●

Press the input selector on your TV remote control

NOTE

■

HDMI (High Definition Multimedia Interface)

 

until the HDMI signal from the DVD Recorder

 

 

 

HDMI is an interface to enable the digital

 

appears on your TV screen.

 

 

 

 

 

transmission of video and audio data with just a

 

 

 

 

 

 

 

 

single connector. Since HDMI is based on DVI, it

 

 

 

 

is completely compatible with DVI. The only

 

 

 

 

difference between HDMI and DVI is that HDMI

 

 

 

 

supports multi-channel audio.

 

 

 

 

Using HDMI, the DVD Recorder transmits a

 

 

 

 

digital video and audio signal and displays a vivid

 

 

 

 

picture on a TV having an HDMI input jack.

 

 

 

■

HDMI connection description

 

 

 

 

HDMI connector - Both uncompressed video data

 

 

 

 

and digital audio data (LPCM or Bit Stream data).

 

 

 

 

- Though the DVD Recorder uses a HDMI cable,

 

 

 

 

the DVD Recorder outputs only a pure digital

 

 

 

 

signal to the TV.

 

 

 

 

- If TV does not support HDCP (High-bandwidth

 

 

 

 

Digital Content Protection), snow noise appears

 

 

 

 

on the screen.

 

 

 

■ Why does Samsung use HDMI?

 

Case 2 : Connecting to a TV

 

 

Analog TVs require an analog video/audio

 

 

 

signal. However, when playing a DVD, the data

 

with DVI Jack

 

 

transmitted to a TV is digital. Therefore either a

 

 

 

digital-to-analog converter (in the DVD Recorder)

 

 

 

 

●

Using the DVI Adapter Cable (not included), connect

 

 

or an analog-to-digital converter (in the TV) is

 

the HDMI OUT jack on the rear of the DVD Recorder

 

 

required. During this conversion, the picture

 

to the DVI IN jack of your TV.

 

 

quality is degraded due to noise and signal loss.

●

Using the audio cables, connect the AUDIO (red and

 

 

HDMI technology is superior because it requires

 

white) OUT jacks on the rear of the DVD Recorder to

 

 

no D/A conversion and is a pure digital signal

 

 

 

from the DVD Recorder to your TV.

 

the AUDIO (red and white) IN jacks of your TV. Turn

 

 

 

 

 

 

 

on the DVD Recorder and TV.

 

■

What is the HDCP?

●

Press the input selector on your TV remote control

 

 

HDCP (High-bandwidth Digital Content

 

until the DVI signal from the DVD Recorder appears

 

 

Protection) is a system for protecting DVD

 

on your TV screen.

 

 

content outputted via HDMI from being copied. It

 

 

 

 

provides a secure digital link between a video

 

■ To watch through the HDMI output, set the

 

 

source (PC, DVD, etc) and a display device (TV,

 

digital audio output to PCM. (See page 30)

 

 

projector, etc). Content is encrypted at the source

CAUTION

 

 

device to prevent unauthorized copies from being

 

 

 

 

■ Depending on the HDMI device (TV/HDMI

 

made.

Receiver) you use, audio may not be

 

 

 

supported. If TV does not support Dolby

 

 

 

 

digital/DTS, Audio output is not available when

 

 

you set Digital output as Bitstream or select

 

 

DTS On in Audio setup menu. In this case, set

 

 

the digital audio output to PCM or DTS Off.

 

 

 

 

 

Connecting & Setting Up

English -21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents DVD-R135 Getting Started EnglishImportant Safety Instructions PrecautionMaintenance of Cabinet Handling CautionsUsing CD-R/-RW Disc SpecificationsUsing MPEG4 disc Disc StorageDVD-RW Video mode DVD-RW VR modeReverse engineering or disassembly is prohibited Do not use the following discsContents Recording the current TV programme you are Flexible Recording for Timer recording onlyRecording from external equipment you are Making a One Touch Recording OTRGeneral Features Manual Recorder Before reading the user’sSelect the disc type Format the disc to start recordingWhen using a DVD-RW disc in Video Mode When using a DVD-RW disc in VR ModeWhen using a DVD-R disc Creating a playlist DVD-RW in VR modePreparing the Remote Control AccessoriesSetting the Remote Control UnpackingControllable TV Codes Description Front PanelFront Panel Display Rear Panel Connect the output of external equipment using audio cablesRF in / RF OUT Connects antenna cables Video OUTgood video qualityTour of the Remote Control Components and required initial setting modes Connecting the DVD Recorder to other externalConnecting the DVD Recorder Quick OverviewConnecting the DVD Video, Component video and Progressive Output ModesRF cable connection of this DVD Case 2 Connecting to an S-Video output jack Case 1 Connecting to a Video Composite output jackCase 3 Component Video output jacks If your TV has audio input jacks, use this connectionComponent jacks will not output See pages 21 Case 2 Connecting to a stereo amplifier with AV output jacks Case 1 Connecting to a TV with Hdmi Jack Connecting HDMI/DVI to aCase 2 Connecting to a TV With DVI JackCase 2 Connecting a Camcorder to the DV in jack Connecting to AV 2 IN, DV input jackCase 2 Connecting a Camcorder to the DV in jack If the input is not selected automaticallyOn-screen Menu Press again to exit the on-screen Menu On-Screen Menu NavigationConnect the RF cable as indicated on Plug & Auto Set upPlug the DVD Recorder into the mains Auto Channel scan will be startedPress the OK button, then the date and time will be saved Setting the ClockPress the OK button to continue Press the OK button to stop the Auto SetupChannel scan will be started If you want to exit, press the Menu buttonCH Tune the channel using œ √ buttons Setting up the Language OptionsLanguage setup menu will be displayed Edit You can add or edit PRprogrammePress the Return or œ button to return EP Mode Time SettingSystem menu will be displayed To the previous menu Press the Menu button to exit the menuWith the DVD Recorder in Stop mode, press the Menu button Automatic Chapter CreationPress the œ √ buttons to select Yes and press the OK button Press the …† buttons to select ChapterAudio setup menu will be displayed Setting up the Audio OptionsOff Doesn’t output DTS signal Audio OptionsThis is only active when a Dolby Digital signal is detected Setting up the Progressive scanDynamic Compression Off You can enjoy the movie with the standard Dynamic RangeThis function allows you to setup the TV screen settings Canceling the Progressive scanVideo setup menu will be displayed If you press the P.SCAN button byDisplayVideo Options HDMI/DVI ResolutionOutput selection TV AspectIf you forgot your password DivXR Registration Setting up the Parental ControlPress the OK or √ button to select Password ‘Create the password’ message will be displayedPress the …† buttons to select Change Password About the Change PasswordSee page 34 if you forgot your password About the Rating LevelBefore Recording Recordable discsCompatibility between Samsung and Other Company’s Recorder DVD-RWVR mode Recording ModeRecording Formats Unrecordable videoAbout Info Button Recording the current TV programme you are watchingChecking the available disc space Disc Information Press the OPEN/CLOSE button to close the disc trayPress the REC button Front panel display changes in the following sequence Recording from external equipment you are watchingCopying from a Camcorder Making a One Touch Recording OTR TV Programme 1 toPress the Stop button once more to stop recording With the DVD Recorder in Stop mode, press the Timer button Making a Timer RecordingSet timer recording option Speed Recording ModeFlexible Recording For Timer recording only If the timer settings overlapPress the OK button Selected entry will be deleted from the list Press the OK button to confirm the edited settingRecording the Standard Timer List Region code DVD-Video only Before PlayingDisc types that can be played Discs that cannot be playedPress the Stop button to stop playback Playing a DiscUsing the Search Functions Using the Disc Menu & Title MenuButton on the remote control Searching through a Chapter or TrackSlow Motion Play Moving to a scene directly using the AnykeyStep Motion Play About AnykeyUsing the Repeat button Using the Repeat FunctionPlaying RepeatedlyRepeat Playback Press the …† buttons to select TimeUsing the Anykey button Unfinalised DVD-RW Video mode do not repeat a chapterRepeat playback of the A-B section starts Using the Audio button Using the Subtitle buttonSelecting the Subtitle Selecting the Audio languageOr pause Changing the Camera Angle Zooming-InUsing Bookmarks Playing back a bookmarkClearing a bookmark Using Markers Playing back a MarkerClearing a Marker Playing an Audio CD CD-DA/MP3 Playing an Audio CD/MP3Playing an Audio CDCD-DA Audio CDCD-DA Screen ElementsPlaying an MP3 Disc MP3 Screen ElementsInsert an MP3 Disc into the disc tray Buttons on the Remote Control used for MP3 playback For MP3 discs, you can select Track, Folder or Disc Play Option ModeTo Programme Tracks Playing a PicturePlaying a MPEG4 When MPEG4 file is played, you can use following functionsInsert a MPEG4 Disc into the disc tray Returns to the Album screenUsing the Menu button Using the Title List buttonPlaying the Title List Press the Menu buttonTitle List screen is displayed Edit menu is displayed on the rightSelected entry title will be played back Limited editing function Title List Screen ElementsDisc Manager Title ListPlaylist Basic Editing Title List Using the Menu buttonRenamingLabeling a Title Rename screen is displayedDeleting a Title LockingProtecting a TitleDeleting a Section of a Title You will be prompted with a confirmation messageEdit Title List screen is display OK button Press the OK button at the starting pointPress the OK button at the end point Edit Title List Screen ElementsPress the OK button at the start point Creating a PlaylistTo make a new playlist To return to Edit Playlist menuAPR/23/2006 Title Playing Entries in the PlaylistRenaming a Playlist Entry Enter the desired characters using the …† œ √ buttonsPlaying a Selected Scene Editing a Scene for the PlaylistEdit Scene screen is displayed Playlist entry to be played is selectedPress the OK button at the start point of the scene To setup, follow steps 1 to 3Press the OK button at the end point of the scene Modify Scene screen is displayedAdding a Scene Press the OK button at the starting point of the sceneSelected scene is moved to the selected position To setup, follow the steps 1 to 3 Using the Play List buttonCopying a Playlist Entry to the Playlist Deleting a SceneUsing the Playlist button Deleting a Playlist Entry from the PlaylistYou can create up to 999 scenes on one Editing the Disc Name Disc ManagerFormatting a Disc Disc ProtectionAll title lists are deleted Delete All Title ListsDisc is finalised Finalising a discDVD-RW can be finalised or unfinalised in VR mode Unfinalising a disc V/VR modePower TroubleshootingRecording Cannot record TV programmesPlay mode settings are different from the settings PlaybackVideo Sound Timer RecordingRemote Control Forgot my password for parental supervisionOther Specifications Region Country Customer Care Centre Web Site English
Related manuals
Manual 180 pages 57.47 Kb
Top Page Image Contents