Cooling Your Room
You must select the Cool mode if you wish to adjust the :
◆Cooling temperature
◆Fan speed when cooling
1If necessary, press the 
(On/Off) button.
Result: ◆ The power indicator on the control panel comes on.
◆The indoor unit beeps.
◆The air conditioner starts up in the Cool mode.
IMPORTANT The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being:
◆Switched on
◆Stopped
lt will start up normally after three minutes.
2If the 
is not displayed on the control panel, press the 
button on the remote control one or more times until it appears.
Result: ◆ The indoor unit beeps each time you press the 
button.
◆The air conditioner runs in the Cool mode.
Note You can change modes at any time.
3To adjust the temperature, press the 
buttons on the remote control or 
buttons on the control panel one or more times until the required temperature is displayed. Possible temperatures are between 18OC and 30OC inclusive.
Result: ◆ Each time you press the 
buttons:
-The temperature is adjusted by 1OC.
-The indoor unit beeps.
◆The air conditioner starts cooling, provided that the room temperature is higher than the selected temperature.
◆If the room temperature reachs the set temperature, the air conditioner stops cooling, but the fan is still operating.
4Select the fan speed by pressing the 
button on the remote control
or 
button one or more times until the required setting is displayed :
Automatic(rotated : 
➔ 
➔ 
➔ 
)
Low
Medium
High
Result: ◆ Each time you press the 
button, the indoor unit beeps.
5To control the direction of the air flow, refer to page 16.
ENGLISH