WASHINGPROCEDURE
TO WASH .........................................................................................................................................................................
1.Before starting washing, check the following;
Connect the water supply hose and open the water tap.
Connect the power cord to the power supply outlet.
Lay the drain hose(A) down toward a sinkhole.
Place the drain hose(A) in sink or bath about 70~80cm above the ground.
2.Set the WASH SELECTOR KNOB to the desired mode. ‘NORMAL or HEAVY’
3.Set the CYCLE SELECTOR KNOB to ‘WASH.RINSE’. (In case no drain pump.) (‘WASH’ In case drain pump.)
(WITHOUT PUMP) | (WITH PUMP) |
6.Fill water in the wash tub to the‘‘ L1’’lower
water level by carefully adjusting the tap water and add the detergent.
7.Set the WASH TIMER 1-35 minutes.
SOAK
Set the WASH TIMER to the point more than“15”for SOAK function.
If the WASH TIMER is set to the point less than“15”, it leads to WASH only. (No SOAK)
If Although the machine may stay still maximum
5 minutes, if the WASH TIMER is indicated over 15 minutes position, it is just in the process of soaking
and not a breakdown.
8. After washing,set the CYCLE SELECTOR KNOB to ‘DRAIN’ for drain.
9.
1)Place clothes into the WASH TUB.
2)Turn on tap or use bucket to fill the WASH TUB with desired amount of water.
3)Put detergent depending on the water volume and detergent package indications.
4)Set WASH TIMER to point between“15”to“35”in the timer.
The SOAK function (20 min.) repeats the cycle that is 1.5 ~ 2.0 min. turning and the next 5 min. resting 3 times.
4. Set the WATER SELECTOR KNOB to 
WASH.
5. Put the cloths into the wash tub and set the same water pressure to fill the tub so as not to exceed ‘H3’level wash tub and set the same water pressure to fill the tub so as not to exceed ‘H3’level..
4
5:24:58