M a i n t e n a n c e
Clearing Blockages
Disconnect cleaner from electrical outlet.
The hose on the back of the vacuum cleaner that carries the dirt from the nozzle to the Dirt Cup can sometimes become clogged. If you notice a change in the sound of the vacuum motor, check for blockages.
Remove Dirt Cup and check Upper Tank and Louvers.
Check to make sure Louvers are Installed correctly. To unlock the Louvers, grasp the rim and turn Toward the left. Pull straight down to remove. If the Louvers are missing or not locked into place, check and clear the tube in the center of the Dirt Cup.
Remove the Hose and disconnect the Wand.
Check for clogs in the vacuum base, the wand, the hose and the suction inlet.
If the blockage persists, turn the vacuum cleaner off and unplug it. Remove the bottom plate. Lift up the short hose in the base of the vacuum. Inspect the hose for clogs and remove any obstructions. Replace the short nozzle hose and the bottom plate.
Tro u b l e s h o o t i n g
Check this list of possible problems and solutions before bringing your vacuum to a service center.
Problem: Cleaner won’t run
Possible Cause
Possible Solution
•Not firmly plugged in
•Plug unit in firmly
•No voltage in wall plug
•Check fuse or breaker
•Blown fuse or tripped breaker
•Replace fuse or reset breaker
Problem : Dust escapes the Dirt Cup
Possible Cause
Possible Solution
•Dirt Cup improperly installed
•
Problem : Poor job of dirt pickup
Possible Cause
Possible Solution
•Full or clogged Dirt Cup
•Empty the Dirt Cup and check for blockages.
•Broken or worn belt
•Replace belt.
•Clogged hose or nozzle
•Clean hose or nozzle area.
•Hole in hose
•Replace hose.
•Dirt Cup improperly installed
•Properly install the Dirt Cup
•Incorrect carpet height setting
•Rotate nozzle control knob to lower setting
•Clogs in air flow passage
•Clear clogs.
Problem : Cleaner hard to push |
| Problem : Abnormal sound |
Possible Cause |
| Possible Cause |
Possible Solution |
| Possible Solution |
• Incorrect carpet height setting |
| • Strange sound like rushing air |
• Rotate nozzle control knob to lower setting |
| • Check for blockages |
6