Samsung VCU2911S4B/XEU Operation, ON-OFF Switch Handle positions, Carrying handle, Flexible rugs

Operation

2-1

ON-OFF Switch

2-2

Handle positions

2-3

Transporting cleaner

1.To turn cleaner on, press the Power switch.

2.To the cleaner off, press the Power switch again

The handle of your cleaner has three positions; upright for storage and when using cleaning tools; operating for general operation on carpet and floors; low for reaching under low furniture. Step on handle release pedal to lower handle.

To move your cleaner from room to room, put the handle in upright position, tilt the cleaner back on its rear wheels and push forward.

2-4

Carrying handle

The cleaner can also be moved by using the carrying handle.

2-5	A
B
C
•option

When using the attachments, ensure the vacuum cleaner is placed firmly on the floor with the handle in the upright position. Do not place the vacuum on top of furniture or steps as the brushroller may cause damage.

A. Combination tool:

Two types of cleaning tools are included in one attachment: rotate for desired tool.

•Use brush side to dust furniture, blinds, books, lamps, shelves. •Use upholstery side for curtains, draperies, cushions, fabrics.

B. Crevice tool:

Use in corners, on stairs, baseboards, and behind furniture.

2-6

Cleaning lightweight

flexible rugs

Stand on one end of rug and move cleaner toward other end or edge. Before reaching edge, push down on handle. This will lift up the nozzle(front of cleaner)and will prevent rug from clinging to cleaner.

Continue to lift front of cleaner so that when you have reached the edge, it is completely off the rug. Move cleaner back to start again, lower front of cleaner, and use only forward strokes.

Cleaning Tool attachments C. Extension Wand:
Attachment tools can be used to		Use with desired attachments and narrow
		wand for a longer reach.
clean furniture or drapes, on stairs
		•option : Mini Turbo Brush
or in corners.
		Refer to the separated instruction.
		Cleaning Tool attachments
	2-7
		Carpet and rug cleaning takes place at the
		nozzle (A).
		When it is necessary to raise and lower the
		nozzle for various carpet pile heights, rotate the
		nozzle control dial (B) to the desired setting.
		For maximum cleaning performance, The
	2-8	following carpet height settings are recommended:
		•Lowest setting: for all types of carpet
		•Higher settings: for very deep pile carpet where
		easier pushing effort is desired, while maintaining
		good cleaning performance.
		Note: If the cleaner is difficult to push, rotate knob to
		the next higher setting.

3