Viewing the Various Functions on Your System
You can view the various functions available on your system.
1 Press the Demo button.
Result: The various functions available are listed in turn on the dis- play.
Setting the Clock
GB
Your system is equipped with a clock which allows you to turn your system on and off automatically. You should set the clock:
When you purchase the
After a power failure
After unplugging the unit
All these functions are described in detail in this booklet. For instructions on how to use them, refer to the appropriate sections.
2 To cancel this function, press Demo again.
1 |
2 |
3 |
4 |
5 |
6 |
Remember to reset the time when the clock changes from winter to summer time and vice verse.
For each step, you have a few seconds to set the required options. If you exceed this time, you must start again.
Switch the system on by pressing Standby/on.
Press Timer/Clock twice.
Result: CLOCK is displayed.
Press Enter.
Result: The hour flashes.
To... | Press the... |
Increase the hours 
Decrease the hours
When the correct hour is displayed, press Enter.
Result: The minutes flash.
To... | Press the... |
NTSC/PAL Selection Method
According to a DISC or TV, Press the REC/Pause button on the front panel.
Set the system to standby(power off) mode, press the REC/Pause button on the front panel.
Result: Each time the REC/Pause button is pressed, the following appears in the display:
NTSC 
PAL 
Increase the minutes 
Decrease the minutes
7 | When the correct time is displayed, press Enter. |
| Result: The clock starts and is displayed, even when the system is in |
standby mode.
You can display the time, even when you are using another function, by pressing Timer/Clock once.
1 |
|
2 | 3,5,7 |
4,6 | 4,6 |
13