Samsung SSC-5000N manual Change Password, Protocol Port1/Port2, Baud Rate, Duplex, Menu Setup

Protocol Port1/Port2

The protocol of the RS-485 communication can be set.

RS-485 communication of the system keyboard supports Camera Protocol as follows.

Choose one protocol among SAMSUNG / Pelco-D / Pelco-P / Vicon / Panasonic / Kalatel / Diamond / AD / Philips / Erna / VCL TP / Techwin / Honeywell.

M You can control two protocols simultaneously by specifying different protocols for Port 1 and Port 2.

M The multimedia protocol provided by us may not be supported depending on the installation conditions. Please contact us or the store of your purchase if you have a problem or question about installing the protocol.

			RS-485 Communication Setup
Keyboard
		¨ Address		Set	0		AD
	Setup			SAMSUNG
		¨ Protocol		1(Port 1)		SAMSUNG
				Pelco-D			Philips
		¨ Protocol		1(Port 2)		SAMSUNG
				Pelco-p			Erna
		¨ Baud RateVicon			9600VCL TP
		¨ Duplex		Panasonic		HalfTechwinDuplex
				Kalatel			Honeywell
				Diamond
		RS-485 Communication Setup
Keyboard
		¨ Address		Set	0		AD
	Setup			SAMSUNG
		¨ Protocol		1(Port 1)		SAMSUNG
				Pelco-D			Philips
		¨ Protocol		1(Port 2)		SAMSUNG
				Pelco-p			Erna
		¨ Baud RateVicon			9600VCL TP
		¨ Duplex		Panasonic		HalfTechwinDuplex
				Kalatel			Honeywell
				Diamond

M MENU SETUP

Baud Rate

The Baud Rate of the RS-485 communication can be set.

1.Press <Baud Rate> and a pop-up window will appear as shown in the right figure.

RS-485 communication of the system keyboard supports Baud Rate as follows.

2.1200/ 2400/ 4800/ 9600/ 19200/ 38400.

Among these 6 kinds of Baud Rate, select one Baud Rate.

			RS-485 Communication Setup
Keyboard		¨ Address Set		0
	Setup
		¨ Protocol (Port 1)		1200
				SAMSUNG
		¨ Protocol (Port 2)		2400
				SAMSUNG
		¨ Baud Rate		9600 4800
		¨ Duplex		9600
				Half Duplex
				19200
				38400

Duplex

1.You can set the duplex mode of system keyboard.

Press <Duplex>, and then the following window pops up.

2.Full Duplex / Half Duplex. Select one of the two duplex.

M Press the <EXIT> icon on the lower left to finish RS-485 COMMUNICATION SETUP control and return to the KEYBOARD SETUP screen.

CHANGE PASSWORD

			RS-485 Communication Setup
Keyboard		¨ Address Set		0
	Setup
		¨ Protocol (Port 1)		SAMSUNG
		¨ Protocol (Port 2)		SAMSUNG
		¨ Baud Rate		9600
		¨ Duplex		HalfFull DuplexDuplex
				Half Duplex

This function is to change the operator's password of the system keyboard.	Keyboard	Change Password
	Setup	Enter Operator No.
		Enter Password

Clear

Enter

1.	At first, enter the current Operator No. and Password.	Keyboard	Change Password
2.	Correctly entered, the screen will change into a window as follows.	Setup	Enter New Password
			¾¾¾¾¾¾

Confirm New Password

¾¾¾¾¾¾

Clear

Enter

English _23